Need help?Do you have a question about the GDC SX-2001 and is the answer not in the manual?
General| Brand | GDC |
|---|---|
| Model | SX-2001 |
| Category | Home Theater System |
| Language | English |
Lists hardware and software included in the upgrade package kit.
Specifies components to be returned after the SX-2001/SA-2100 upgrade.
Instructions to create an OS partition snapshot using Rescue mode before upgrading.
Important note regarding server and IMB serial numbers matching for the upgrade.
Step-by-step guide to detach the mounting holder from the server.
Instructions on cutting a plastic cable holder to access a DCI card fan connector.
Procedure to detach the flat cable from the DCI side.
Steps to un-install the DCI card by un-securing a screw.
How to un-install the GPI/O card by un-securing a screw.
Procedure to un-install the sound card by un-securing a screw.
Instructions to remove the vented back plate by un-securing a screw.
Installing a back plate to cover unused PCI slots for SX-2000 configuration.
Steps to insert a gigabit network card and perform software upgrade for TMS/LMS.
Guide to installing a mounting holder in the server case for the network card.
Details on Ethernet cable connections for server, IMB, and projector.
Identifies the network cable and the IMB unit as key components.
Instructions for removing existing boards and placing the IMB into Barco and Christie projectors.
Procedure for inserting the IMB into the projector, ensuring flush fit.
How to connect the IMB on the projector to the server using network cables.
Information regarding sha256 certificate updates and KDM issuance after upgrade.
Steps to run the ServerID upgrade, a prerequisite for the main upgrade.
Detailed steps for applying Upgrade Package 1 using a USB disk.
Instructions for applying Upgrade Package 2, including case-specific scenarios.
Configuration steps for Barco Series 2 projectors to work with GDC IMB.
Steps to configure NEC Series 2 projectors for IMB compatibility via Digital Cinema Communicator.
Procedure for installing and configuring Christie Series 2 projectors with GDC IMB.
Specific 3D input control settings for Christie Series 2 projectors.
Macro changes for Barco S2 projectors to support IMB 3D output in '4:4:4' format.
Macro changes for NEC Series 2 projectors to use '4:4:4' input for IMB 3D output.
Configuration check for Christie Series 2 projectors for IMB 3D 4:4:4 output.
Steps to prepare and update the SOM OS for the IMB.
Procedure to update or set the SOM OS serial number using a CF card.
Detailed pin layout for IMB audio and GPIO ports.
To Next Page
