GDP EZ LYNK Auto Agent

To Next Page

GDP

Quick Guides

page 1

Step 6

Open the AutoAgent™ and verify that your vehicle reads ‘Connected’.

How to establish a connection With your vehicle

Step 1

Unplug the AutoAgent™ directly from the OBD-II port.

Step 2

Boot your ECM by placing your key into the ‘Run’ position.

Step 4

Verify that a solid blue light is visible on the AutoAgent™ device.

If only a

green light is visible, unplug and replug.

Step 3

Plug the AutoAgent™ directly into the OBD-II port.

Step 5

Connect to the EZLYNK_#### network from your mobile device.

How to Change your vehicle details

Step 1

From the Vehicles screen of the app, select your vehicle.

Step 2

Select Vehicle Details and then select Edit.

Step 4

Select an ECU profile that you wish to install to apply the changes.

Changes are not applied automatically and must be programmed.

Step 3

Adjust your details to fit any vehicle modifications or desires.

Step 5

When your installation has finished, verify any changes made to your vehicle.

Use the following steps to adjust and apply vehicle details using the AutoAgent™ app.

Use the following steps to establish a new connection with your AutoAgent™

and ensure vehicle communication.

www.GDPTUNING.com

Need help?

Do you have a question about the GDP EZ LYNK Auto Agent and is the answer not in the manual?

Summary

Establish Vehicle Connection

STEP 1 UNPLUG AUTOAGENT

Unplug the AutoAgent device directly from the OBD-II port.

STEP 2 BOOT ECM

Boot the ECM by placing the vehicle's key into the 'RUN' position.

STEP 3 PLUG AUTOAGENT

Plug the AutoAgent device directly into the OBD-II port.

STEP 4 VERIFY AUTOAGENT LIGHT

Check for a solid blue light on the AutoAgent device; replug if a green light is visible.

STEP 5 CONNECT TO EZLYNK NETWORK

Connect your mobile device to the EZLYNK_#### network.

STEP 6 VERIFY VEHICLE CONNECTION

Open the AutoAgent app and verify the vehicle reads 'CONNECTED'.

Change Vehicle Details

STEP 1 SELECT VEHICLE

Select your vehicle from the Vehicles screen in the app.

STEP 2 SELECT EDIT

Select 'Vehicle Details' and then select 'Edit'.

STEP 3 ADJUST DETAILS

Adjust vehicle details to fit any modifications or desires.

STEP 4 SELECT ECU PROFILE

Select an ECU profile to apply changes; programming is required.

STEP 5 VERIFY CHANGES

Verify any changes made to the vehicle after installation.

Link Vehicle with GDP Technician

STEP 1 OPEN AUTOAGENT APP

Open the AutoAgent app while connected to internet or mobile data.

STEP 2 SELECT VEHICLE TO LYNK

Select the desired vehicle from the app menu to link.

STEP 3 TAP TECHNICIANS BUTTON

Tap the 'Technicians' button and select 'Lynk'.

STEP 4 ENTER TECHNICIAN EMAIL

Enter the technician's email address or contact GDP if none provided.

STEP 5 DESCRIBE MODIFICATIONS

Describe vehicle modifications and select 'Done'.

STEP 65 REQUEST PROFILES

Contact GDP via email, phone, or in-app for profile requests.

Contact GDP Technician

STEP 1 OPEN VEHICLES TAB

Open the Vehicles tab in the AutoAgent app.

STEP 2 VIEW TECHNICIAN DETAILS

Select 'Technicians' to view details and the tech's name.

STEP 3 CONTACT DEALER IF NEEDED

Contact dealer if vehicle is linked with zero technicians.