Need help?Do you have a question about the GE HEALTHCARE CU-960 and is the answer not in the manual?
Describes CU-950 and provides information on how to install this control unit with ÄKTAexplorer, ÄKTApurifier, ÄKTAFPLC, and ÄKTApilot.
CU-960 is the standard control unit delivered with ÄKTAprocess and ÄKTAready systems.
Details the CU-950 unit's components, connectivity options (USB, Ethernet/Advance mode), and IP address designation.
Describes the CU-960 controller card, its independent power supply, Ethernet interface, and Profibus support.
Explains the functions of the Power, PC, and System LEDs and their status indications.
Details the ports on the back panel including power input, Profibus, USB, Ethernet, and test ports.
Shows how to mount the CU-950 on ÄKTAexplorer/ÄKTApurifier, schematic cable connection diagrams, and steps for connecting cables.
Details mounting the CU-950 on ÄKTAFPLC, schematic cable connection diagrams, and instructions for connecting cables.
Explains placing the CU-950 unit and power converter, and shows schematic cable connections and setup for ÄKTApilot.
Describes the pre-installed nature of CU-960 in ÄKTAprocess systems and its mounting in a rack adaptor.
Explains how the 128 MB flash memory card buffers run data during operational failures like power loss.
Lists error IDs, messages, causes, and suggested actions for controller card errors.
Details error IDs, messages, causes, and suggested actions for method executor errors.
Lists SAP error codes and issues related to UniNet controller communication and message handling.
Covers error messages related to instrument communication, CAN driver, and specific error conditions.
Details the connection of the CU-960 to the system computer in ÄKTAready, focusing on waterproof connectors and LAN cable types.
General| Brand | GE HEALTHCARE |
|---|---|
| Model | CU-960 |
| Category | Control Unit |
| Language | English |
To Next Page