GE 16 - Oven Controls Overview; Oven Control, Clock and Timer Features

Using the oven controls. (on some models)
Throughout this manual, features and appearance may vary from your model.
BAKEPad
TIMER Pad
Ol
•
Touch this pad to select the bake function.
•
Touch this pad to select the timer feature.
c:
Then touch the + and - pads to adjust the timer.
'-
c:
BAKE Light
0
Flashes while in edit mode-you can change
TIMER Light
0
the oven temperature at this point. Glows when Flashes while in edit mode-you can change
the oven is in bake mode. the set time at this point. Glows when the timer
"'0
c:
has been activated. Flashes again when the time
0
START/ON Pad
has run out until the control is reset.
•
Must be touched to start any cooking or cleaning
~
function.
A CLOCKPad
0
U
VI To set the clock, press this pad twice and
Display
then press the + and - pads. The time of day
•
Shows the time of day, oven temperature,
will flash in the display when the oven is first
whether the oven is in the bake. broil or
turned on.
CI)
self-cleaning mode and the times set for
.Q..
.::
the timer or automatic oven operations .
e
START TIME Pad (on some models)
The display will show PRE while preheating.
~ Use along with the COOK TIME or CLEAN pads
Ol
c:
When the oven reaches the selected to set the oven to start and stop automatically
:0
temperature. the oven control will beep and at a time you set.
0
0
the display will show the oven temperature.
.c:
START TIME Light
CI)
If "F- and a number or letter" flash in the display and the
Flashes while in edit mode-you can change the
~
oven control signals. this indicates a function error code.
start time at this point. Glows when the function
..Q
:l
has been activated.
If your oven was set for a timed oven operation
e
and a power outage occurred. the clock and all
COOK TIME Pad (on some models)
~
programmed functions must be reset.
Touch this pad and then touch the + or - pads
The time of day will flash in the display when there to set the amount of time you want your food
•
has been a power outage. Reset the clock.
to cook. The oven will shut off when the cooking
t
0
time has run out.
If the function error code appears during the self-cleaning
8:
cycle. check the oven door latch. The latch handle may
COOK TIME Light
:l
have been moved. even if only slightly, from the latched
V)
Flashes while in edit mode-you can change the
position. Make sure the latch is moved to the right as far
L-
set time at this point. Glows when the function
eu
as it will go.
has been activated. Flashes again when the time
E
Touch the OFF pod. Allow the oven to cool for one
has run out until the control is reset.
:l
CI)
hour. Put the oven back into operation. If the function
c:
error code repeats, disconnect the power to the range
0
U
and call for service.
10
Oven Control, Clock and Timer Features and Settings