GE 16 - Page 45

Using the clock, timer and convenience outlet. (on some models)
GEAppliances.ca
Not all features are on all models.
To Set the Clock
The clock must be set to the correct time
of day for the automatic oven timing
functions to work properly. The time of day
cannot be changed during a timed baking
or self-cleaning cycle.
[l] Touch the CLOCK pad twice.
[£] Touch the + or - pads.
If the + or - pads are not touched within
one minute after you touch the CLOCK pad,
Make sure the clock is set to the correct
the display reverts to the original setting.
time of day.
If this happens, touch the CLOCK pad and
reenter the time of day.
[1] Touch the START/ON pad until the time
of day shows in the display. This enters
the time and starts the clock .
To check the time of day when the display
is showing other information. simply touch
the CLOCK pad. The time of day shows until
another pad is touched.
To Turn Off the Clock Display
If you have several clocks in your kitchen,
you may wish to turn off the time of day
clock display on your range.
[l] Touch the CLOCK pad once to turn
off
the time of day display. Although
you will not be able to see it, the clock
maintains the correct time of day.
[£] Touch the CLOCK pad again to recall
the clock display.
The timer is a minute timer only .
The OFF pad does not affect the timer .
To Set the Timer
The timer does not control oven operations.
The maximum setting on the timer is 9 hours
and 59 minutes.
[l] Touch the TIMER pad.
[£] Touch the + or - pads until the amount
of time you want shows in the display .
The maximum time that can be entered
in minutes is 59. Times more than
59 minutes should be changed
to hours and minutes.
tf you make a mistake, touch the TIMER pad
and begin again.
[II Touch the START/ON pad. The time
will start counting down, although
the display does not change until
one minute has passed.
[£] When the timer reaches :00, the control
will beep 3 times followed by one beep
every 6 seconds until the TIMER pad
is touched.
15