Preparing to install the refrigerator.
22
Operating Instructions
Installation Instructions
Safety Information
Troubleshooting TipsCustomer Service
Read these instructions completely and carefully.
Water Supply to the Icemaker
(on some models)
If the refrigerator has an icemaker, it will have to be connected to a
cold water line.
A water supply kit (containing copper tubing, shutoff valve, fittings
and instructions) is available at extra cost from your dealer.
Do not install the refrigerator where the temperature will go below
60°F. (16°C.) because it will not run often enough to maintain
proper temperatures.
Install it on a floor strong enough to support it fully loaded.
Refrigerator Location
Allow the following clearances for ease of installation, proper air
circulation and plumbing and electrical connections:
Sides 3/4″ (19 mm)
Top 1″ (25 mm)
Back 1″ (25 mm)
If a 19′, 22′ or 25′ model is to be installed next to a wall on the hinge
side, allow 1
1
/
2
″ (44 mm) for door clearance.
Clearances
To Next Page
Loading...
