The chime and pushbutton must be set to the same house security code for the
combination to operate together.
Note: The push button has 3 additional jumpers that are used to set the chime
tune that will play. The chime tune jumpers do not affect the house security code.
1. Remove power or batteries from the chime.
2. To remove the batteries from the pushbutton, open the pushbutton case
as shown below.
3. Locate the House Security Code door and screw located on the
back of the AC Chime. Remove the screw and take off the door.
4. Locate the chime and pushbutton jumpers shown below.
To Next Page
Loading...
