GE 24178 - Setting the Security Code

17
Setting the Security Code
This feature allows you to change the factory default remote access code used for
remote access to you answerer. The default code is 123.
1. Press and release the
MENU button until the screen displays REMOTE ACCESS”
2. The left-most digit, or a (_) sign ashes indicating the unit is ready to accept the
security code entry.
3. Use the keypad number to set the 3-digit security code in one step.
4. After the 3rd and last digit is entered, press the
MENU button to store the security
code and go to the next setting.
NOTE: To skip to the next setting, press MENU. To exit setup, press
EXIT.
NOTE: If you make a mistake, you can use SKIP or REPEAT to move
between 1st to 3rd digit and input number from keypad again.
Setting the Display Contrast
This setting allows you to adjust the display contrast for easier readability.
1. Press and release the
MENU button until the screen displays CONTRAST.
2. Use
SKIP or REPEAT to select the desired setting (1-5).
3. When nished, press
MENU to conrm and go to the next setting.
NOTE: To skip to the next setting, press MENU. To exit setup, press EXIT.