11
Using Your Remote
Master Volume Feature
The Master Volume Feature allows you to select a
single device (TV or audio receiver) that the volume
control always controls. For example, the remote can
be in TV mode while the volume buttons control the
volume on your audio receiver instead of your TV.
Enabling the Master Volume Feature
1. Press and hold the SETUP button
until the red indicator stays on
(approximately 2 seconds) and then
release the button.
2. Press and release desired device button
(TV, DVD, SAT) for the device you wish to
setup to control the volume.
3. Press and release the MUTE button.
4. Press and release the VOL button. The
red indicator will blink twice and then go
off.
Disabling the Master Volume Feature
1. Press and hold the SETUP button until
the red indicator stays on
(approximately 2 seconds) and then
release the button.
2. Press and release the device button
(TV, DVD, SAT) which is programmed to
control the Master Volume Feature.
3. Press and release the MUTE button.
4. Press and release the
VOL button.
The red indicator light will blink twice
and go off.
To Next Page
Loading...
Need help?
General
