GE 24993 - Direct Code Entry Procedure; Initiate Code Entry Mode; Select Device Mode; Enter 4-Digit Code

7
Direct Code Entry
Write your codes down here for easy reference
later.
1. Press and hold the SETUP button until
the red indicator stays on, then release
the SETUP button.
2. Press and release the desired mode
button (TV, DVR, etc.). The red
indicator blinks, then stays lit.
3. Enter the 4-digit code from the code
tables (on separate
sheet). Note: after a
valid code entry, the
red indicator turns
off. For an invalid
code, the red indicator
ashes.
4. With your device on,
press ON/OFF. If the
device turns off, no
further programming
is required. Note: If
some buttons do not operate your
equipment, try one of the other codes
for your brand.
Device Device stored Code
TV TV
DVD
CBL/SAT
DVR/AUX