49-5000634 Rev. 4 9
INSTALLATION INSTRUCTIONS
Installation Instructions
Questions? Visit our Website at: GEAppliances.com
BEFORE YOU BEGIN
Read these instructions completely and carefully.
• IMPORTANT — Save these instructions for
local inspector’s use.
• IMPORTANT — Observe all governing codes
and ordinances.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these instructions for
future reference.
• Skill level – Installation of this appliance requires
basic mechanical skills.
• Completion time – Approximately 1 hour
• We recommend that two people install this product.
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is not
covered under the Warranty.
<RX0867XVHDOOVXSSOLHGSDUWVDQGXVHSURSHU
installation procedures as described in these
instructions when installing this air conditioner.
TOOLS YOU WILL NEED
CAUTION
Do not, under any circumstances, cut or remove the
third (ground) prong from the power cord.
Do not change the plug on the power cord of this air
conditioner.
Aluminum house wiring may present special
problems—consult a qualified electrician.
Power cord includes a current interrupter device. A
test and reset button is provided on the plug case. The
device should be tested on a periodic basis by first
pressing the TEST button and then the RESET button
while plugged into the outlet. If the TEST button does
not trip or if the RESET button will not stay engaged,
discontinue use of the air conditioner and contact a
qualified service technician.
ELECTRICAL REQUIREMENTS
Some models require a 115/120-volt AC,
60-Hz grounded outlet protected with a
15-amp time-delay fuse or circuit breaker.
The 3-prong grounding plug minimizes the possibility
of electric shock hazard. If the wall outlet you plan to
use is only a 2-prong outlet, it is your responsibility
to have it replaced with a properly grounded 3-prong
wall outlet.
Phillips head screwdriver
Ruler or tape measurePencil
Level
Scissors or knife
UNPACKING THE AIR CONDITIONER
WARNING
EXCESSIVE WEIGHT HAZARD - When moving or
lifting the air conditioner, use two or more people.
Wear gloves when handling the air conditioner to
protect against possible sharp edges and metal fins.
Remove Packaging Materials
• Remove packaging materials. Save the carton and the
foam packaging for storing the unit when not in use.
NOTE: There is NO internal packing material inside
the air conditioner to remove - DO NOT open the
cabinet.
• Handle the air conditioner gently.
• Keep the air conditioner upright and level. Do not
set the air conditioner on its side, front, back or
upside down.
• The air conditioner must be standing upright for 2
hours prior to installation and operation.
SUPPORT VIDEOS
Scan code for installation
support videos.
To Next Page
Loading...
Need help?
General
