27
GEAppliances.com
Replacing the light bulb.
Cooktop Light/Nite Light
Replace with a 120 volt, 40 watt (max.)
halogen bulb. Order WB08X10051 from your
GE supplier.
1
To replace the cooktop light/nite light, first
disconnect the power at the main fuse or
circuit breaker panel, or pull the plug.
2
Remove the screw from the side of the light
compartment cover and lower the cover
until it stops.
3
Be sure the bulb is cool before removing.
Break the adhesive seal by gently
unscrewing the bulb.
4
Screw in the new bulb, then raise the light
cover and replace the screw. Connect
electrical power to the oven.
Remove screw.
Plastic Color Panels
Use a clean, soft, lightly dampened cloth, then dry thoroughly.
Door Seal
It’s important to keep the area clean where the door seals against the microwave. Use only mild,
non-abrasive detergents applied with a clean sponge or soft cloth. Rinse well.
Bottom
Clean off the grease and dust on the bottom often. Use a solution of warm water and detergent.
To Next Page
Loading...
Need help?
General
