The Problem
Solver
(continued)
PROBLEM
WRINKLING IN
PERMANENT PRESS
AND “NO-IRON”
ITEMS (continued)
POSSIBLE CAUSE AND REMEDY
●
Accumulation of lime scale due to use of carbonate detergents. If you must use a
non-phosphate detergent, avoid the use of a high-carbonate detergent.
●
Failure to use fabric softener. Proper use of fabric softener will minimize wrinkling.
To remove
wrinkles:
.
Retumble on “Permanent Press” setting.
.
Rerinse and dry on “Permanent Press” setting.
. If unsuccessful,
retumble on high heat for 10-12 minutes and hang immediately.
. Iron carefully.
c
Send to dry cleaners for pressing.
●
Some
wrirddes
may remain which cannot be removed?
*N~E:
If you
follow
good
laundry procedures and Permanent press clothes
Still COme
out
wrin~ed,
the finish may not be good quality. Also, in permanent press synthetic/
cotton blends, the cotton portion of the fabric can eventually wear away leaving only the
synthetic. Since it’s the cotton portion which is treated for Permanent Press, a loss or
decrease of Permanent Press performance will result.
If
vou
need more
hel~..
call. toll free:
GE Answer Center”” ‘
8W.626.2~
consumer information service
12
To Next Page
Loading...
