-
DDE8200S and DDG8280S
I
Set the Controls —
Controls and features will vary from model to model.
See Suggested Fabric and Drying Selections guide.
~
Drying Selections.
Select the proper heat for
your load.
Should
be used with cycles indicated
●
Automatic
Drying
Automatic
Perm. Press and
Timed
Selections
Regulm
cycle fiits
Cycles
Cycles
Cottons
High Heat
●
●
, Perm. Press
Medium Heat
● ●
hits~elicates
Low Heat
● ●
Huff
No Heat*
●
*Huff-No Heat option can be used with an automatic cycle, but for
best performance it is recommended to be used with a timed cycle.
NOTE:
Drying times will vary according to the
type of heat used (Electric, Natural gas or
LP
gas), size of
load,
types of fabrics, wetness of
clothes, and condition of exhaust ducts.
~
Cycle Selector.
Turn the Cycle Selector to the
desired cycle setting. The selector may be turned
in either direction.
Etira
Care Cycle.
Operates only with the Automatic
Perm. Press and
~ts
cycles. For
modek
DDE9605S/
DDG9685S
and DDE8505S~DG8585S
press the
pad, to select. For
models
DDE8500S~DG
8580S
turn the
control
hob
to SET. To minimize
writie
setting in clothes, the Extra Care cycle provides
approximately 15 minutes of no-heat tumbling after
the clothes are dry. Use End Cycle Signal if your
dryer has one. Signal will sound to remind you to
remove the
cloties.
End Cycle Signal.
Set End
Cycle
Signal, if desired.
For
models DDE%05S~DG9685S and
DDE8505S/
DDG8585S
press the pad, to select. For
modek
DDE8500S~DG8580S turn the
control
hob
to
desired level.
On
modek
DDE9605S~DG9685S
and DDE8505S/
DDG8585S
select
R@et
Options
if you wish to
change an option.
Stirt.
For
models
DDE9605S~DG9685S
and
DDE8505S~DG8585S
press the
Wsh
to Start
button to start the dryer. For
models
DDE8500S/
DDG8580S
and
DDE8200S~DG8280S
turn the
Start
bob
to start the dryer.
(Opening the door during operation stops the
dryer. To restart, close the door and follow above
directions.)
Check the Lint
Ftiter Sort
and Load the Clothes
Clean the lint filter each time the dryer is used.
Good sorting for the dryer begins at the washer.
Always be sure the lint filter is in place. Don’t use
Generally, if clothes are sorted right for washing,
the dryer without it. See the Care and Cleaning section.
they’re sorted right for drying. See the How to Sort
the Clothes section. If you do mix various types of
fabrics in your load, set the controls for the
lighter-
weight fabrics and remove when dry. Reset controls
for the remaining heavier fabrics.
7
To Next Page
Loading...
