GE DLB1550B - How to operate your dryer; Load Your Dryer Properly; Set the Controls; Polyester Knits & Permanent Press drying tips

How to opemte your dryer
WARNING—To reduce the risk of fire, electric shock, or injury to persons,
read the IMPORTANT SAFETY INSTRUCTIONS before operating this appliance.
had Your Dryer Properly.
● Clean the lint filter each time the
dryer is used. Always be sure the
lint filter is in place. Don’t use the
dryer without it.
● Good sorting for the dryer begins
at the washer. Generally, if clothes
are sorted right for washing, they’re
sorted right for drying. See page 8
for sorting help. (If you do mix
various types of fabrics in your
load, set the controls for the
lighter-weight fabrics and remove
when dry. Reset controls for the
remaining heavier fabrics.)
Set the Controls.
See the Controls Setting Guide on
pages 6
and 7.
~Drying Selections
Select the proper heat for your
load.
~TurnCycleSelector to desired
cycle setting. The selector may be
turned in either direction.
@ Turn START knob to start
dryer. (Opening the door during
operation stops the dryer. To
restart, close the door and turn
the START knob.)
Polyester Knifi &
Pemanent Press drying tips
● DO NOT OVERLOAD—
Garments being dried or
dewrinHed should tumble freely.
● REMOVE CLOTHES
PROM~LY—To help prevent
wrin~ing, remove from the dryer
promptly at the end of the drying
cycles.
● PLACE ON HANGERS—
Permanent Press and Polyester
Knit garments look best if placed
on hangers after drying.
5