Aboutthe automaticicemaker. (cont) CeA..lia.ce .com
Models with tilt out ice bin
To access ice and reach the
icemaker power switch:
O Lift the bin, then pull it
forward until the bin stops.
O ower the bin to access ice
or reach the power switch.
Accessing Ice and Reaching
the Power Switch on Dispenser
Models
There are two types of ice storage bins
on dispenser models. Onehas a shelf above
the bin,the other does not.
Special note for models with tilt-out
ice bin:
These models have a tilt-out ice bin.
The bin can be tilted out as shown in
the illustrations, and itwill hold itself
up while gou take ice out or turn the
icemaker power switch on and off.
Be sure to put the bin buck in place
before closing the door.
NOTE: In order to take full advantage of the tilt-
out ice bin, only store items on the shelf below
the ice bin that are no taller than the lowest
point on the bin.
Models with a shelf
above the ice bin
z
z
To access ice, pull the bin forward.
To reach the power switch, pull the
shelf straight out. Always be sure to
replace the shel_
On some models,
to access ice or reach
the power switch:
/
!
O ull the bin forward until the
bin stops.
O ower the bin to access ice
or reach the power switch.
Removing Ice Bin (dispenser models)
CAUTION:The ice bin is heavy when full.
Set the power switch to the OFF position
before removing the bin.
When replacing the bin, be sure to press
it firmlg into place. If it does not go all the
wag back, remove it and rotate the drive
mechanism !/4 turn. Then push the bin
back again.
Drive
Dispenser Models only
13
To Next Page
Loading...
