Performance Data Sheet
SmartWater Filtration Sgstem-GE®MSWF Cartridge
This sgstem has been tested and certified in filter model GE MSWF according to NSF/ANSI Standards 42 and 53 for reduction of the substances listed below.
The concentration of the indicated substances in water entering the sgstem was reduced to a concentration less than or equal tothe permissible limit for water
leaving the sgstem, as specified in NSF/ANSI Standards 42 and 53.* (Safetg factors built in for unmetered usage.)
Standard No. 42: Aesthetic effects
I imfluent Challeng e Effluent
Parameter ' USEPA MCL Concentration ' Average ' Maximum
iiiiBi_B_a_;_!_l!i_i_i_i_i_i_i_i_i_i_i_i_l!li_i_iii_i_ii_i!_!_!_!i_i_i_lilililililililililililililil_;!i!_!_i_i_i_!_!i_:_i#ii_ii_ii_ii_
Standard No. 53: Health effects
I
Parameter ' USEPA MCL
1 NTU_+××
99.95% Reduction
0.010 mg/L
0.010 mg/L
0,002 mg/L
0,002 mg/L
0,0002 mg/L
0,003 mg/L
0.070 mg/L
0,003 mg/L
0,005 mg/L
0.040 mg/L
0,075 mg/L
99% Reduction
2.0 mg/L _+10% 0.06 mg/L 0.10 mg/L
at least 10,000 particles/ 408,333 670,000
mL
Mfluemt Challenge
Concentration
11_+1 NTU××__
Minimum 50,000 L
0.15 mg/L_+ 10%
0.15 mg/L _+10%
0.006 mg/L _+10%
0.006 mg/L _+10%
0.002 mg/L _+10%
0.009 mg/L _+10%
0.210 mg/L _+10%
0.015 mg/L _+10%
0.015 mg/L _+10%
0.080 mg/L _+10%
0.225 mg/L _+10%
107to 108fibers/L;
fibers > lOIAm in length
Effluent
Average
0,38 NTU
< 1 #/L
< 1 ppb
3,1 ppb
0.34 ppb
0.66 ppb
< 0,02 ppb
< 0.5 ppb
7.7 ppb
< 1 ppb
< 0.5 ppb
< 1 ppb
< 0.5 ppb
< 0,17 MF/L
×Tested using pressu re of 60 psig; pH of 7.5 _+0.5; temp of 68 ° _+5oF (20 ° _+2.5oC).
×-×Measurement in Particles/mL Particles used were 0.5-1 microns.
×-×-×Basedon the use of Cryptosporidium parvum oocysts.
............NTU=Nephelometric Turbidity Units
Capacity 300 gallons (1,135 liters). Contaminant reduction determined by NSF testing.
Maximum
0.5 NTU
4 #/L
< 1ppb
9.0 ppb
0.7 ppb
1.5 ppb
< 0,02 ppb
< 0,05 ppb
35 ppb
< 1 ppb
< 0.5 ppb
1 ppb
< 0.5 ppb
< 0,17 MF/L
% Reduction
Average ' Maximum Min. Required Reductior
97% 9.1% _>50%
95.5% 89.4% _>85%
% Reduction
Average
96.5%
> 99.99%
99.3%
98.0%
94.0%
88.4%
> 99.0%
> 93.9%
96.0%
> 92.9%
> 96.8%
> 98.7%
> 99.7%
> 99%
Maximum
95.4%
> 99.99%
99.3%
95.5%
89.6%
73.7%
> 99.0%
> 94.3%
82.0%
> 92.9%
> 97.0%
> 98.7%
> 99,8%
> 99%
Max. Permissible
Product Water
0.5 NTU
99.95%
0,010 mg/L
0.010 mg/L
0.002 mg/L
0.002 mg/L
0,0002 mg/L
0,003 mg/L
0.070 mg/L
0.003 mg/L
0,005 mg/L
0.040 mg/L
0.075 mg/L
99% Reduction
Application Guidelines/Water Supply Parameters
Service Flow ] 0.9 gpm (3.14 Ipm) Water Pressure 40-120 psi (2.8-8.2 bar)
Water Supply / Potable Water Water Temperature 33°F-1 O0°F (0,6°C-38°C)
It is essential that the manufacturer's recommended installation, maintenance and filter replacement requirements _@¢natlieq_mduct to perform as advertised.
See insert for Warranty information.
Operating Specifications
Pressure requirement: 40-120 psi (2.8-8.2 bar), non-shock
Temperature: 33-100°F (0.6-38°C)
Flow rate: 0.9 gpm (3.14 Ipm)
General Installation/Operation/Maintenance Requirements
Flush new cartridge at full flow for 44/2 gallons (about five minutes) to purge
trapped air.
Replace cartridge when flow becomes too slow.
Protect from freezing bg removing filter cartridge when temperatures ore
expected to drop below 40°F (4.4°C). Do not install sgstems in areas where
ambient temperatures mug go above 100°F or below 40°E Do not install
on a hot water supplg.
Special Notices
Installation instructions are included with the product when shipped.
This drinking water system must be maintained according to manufacturer's
instructions, including replacement of filter cartridges.
, Do not use with water that is microbiologicallg unsafe or of unknown qualitg with-
out adequate disinfection before or after the sgstem. Sgstems certifed for cgst
reduction mag be used on disinfected water that mag contain flterable cgsts.
. The contaminants or other substances removed or reduced bg this water
treatment sgstem are not neeessarilg in gour water.
Check for compliance with the applicable state and local laws and regulations.
Note that while the testing was performed under standard laboratorg conditions,
actual performance mag varg. Sgstems must be installed and operated in
accordance with manufacturer's recommended procedures and guidelines.
, Installation and use MUST complg with all state and local plumbing codes, Do not
install if water pressure exceeds 120 psi, If gour water pressure exceeds 80 psi
(552 kPa), gou should install a pressure-limiting valve. Contact a plumbing
professional if gou are uncertain how to check gour water pressure,
Do not install where water hammer conditions mag occur, Ifwater hammer
conditions exist gou must install a water hammer arrester. Contact a plumbing
professional if gou are uncertain how to check for this condition.
Where a backflow prevention device is installed on a water sgstem, a device for
controlling pressure due to thermal expansion must be installed.
For conditions of use, health claims certifed bg the California Department of Public
Health, and replacements, see performance data sheet. California Department
of Public Health Certification #064834, The contaminants or other substances
removed or reduced bg this water filter are not necessarilg in all users' water.
Tested and Certified by NSF International against ANSI/NSF Standards 42 and 53 in model GE MSWF for the reduction of:
Standard No, 42: Aesthetic Effects
, Chemical
Chlorine Taste and Odor
, Mechanical Filtration
Particulate Reduction, Class I
GE
Appliances
Appliance Park
Louisville, KY/40225
geapplianceparts.com
Standard No. 53: Health Effects
, Chemical Reduction
Atrazine Reduction
Endrin Reduction
Benzene and Curbofuran Reduction
1,4 Dichlorobenzene and
2,4 D Reduction
Lead and Lindane Reduction
Mercurg and Toxaphene Reduction
, Mechanical Filtration
Cystand Asbestos Reduction_
REPLACEMENT EL EM ENT
EPA #10350 MN 005
@ 2010 General Electric Compang PC61577C
34
To Next Page
Loading...
