HOW TO CHANGE COLOR PANELS
If you are redecorating, you can change your
The panel is held in place by the door trim and the
dishwasher’s front panels to match or blend with your
trim on the panel below the door. Each side of each
new colors.
panel is a different color. Or you can paint a panel
with the color of your own choice.
How to change door panel insert:
1. Take out trim screws on either side of the
dishwasher door. Remove the side trim.
2. Slide the door panel out.
(Careful—edges may be sharp.)
3. Turn the door panel around and put the color you
want in front.
4. Replace the door panel, side trim and screws.
NOTE: Do not operate
dishwasher while changing
panels or when lower access
panel is removed.
How to change the lower panel:
1.
Remove the panel attachment screws.
Attachment Screws
2. Remove the entire access assembly by lifting it up
and over the retaining tabs.
3. Take out the top trim screws and remove the
top trim.
4. Slide the color panel (s) up and out and put the
color you want in front.
5. Replace the top trim and screws.
6. Replace the entire access assembly by hanging it
back on the retaining tabs and replace the
attachment screws.
Wood panels
A wood panel trim kit, GPF 40, contains trim and
Use the order form on the next page to order,
instructions for adding a decorative wood door panel
without charge, a color panel not supplied with
and lower access panel no thicker than 1/4” to match
your dishwasher or a wood panel trim kit
GPF40.
kitchen cabinets. The kit is available at no extra cost.
(Specify
GPF40).
1A
To Next Page
Loading...
Need help?
General
