About the dial cycles.
Rinse Only
For rinsing partial loads that will be washed
later. Do not use detergent.
Make sure HEATED DRY OFF is selected.
Be sure the door is unlatched.
Slowly turn the Dial to RINSE ONLY.
Latch the door to start the cycle.
4
3
2
1
OFF
NORMAL WASH
HEAVY WASH
PLATE WARMER
(HEATED DRY ON)
RINSE ONLY (HEATED DRY OFF)
HOT START
OPTION
SHORT
WAS H
Plate Warmer
For warming clean dishes and serving
plates. This cycle will take approximately
32 minutes.
Load clean dishware to be warmed.
Select HEATED DRY ON.
Be sure the door is unlatched.
Slowly turn the Dial to PLATE WARMER.
Latch the door to start the cycle.
5
4
3
2
1
OFF
NORMAL WASH
HEAVY WASH
PLATE WARMER
(HEATED DRY ON)
RINSE ONLY (HEATED DRY OFF)
HOT START
OPTION
SHORT
WAS H
Operating Instructions Safety InstructionsConsumer Support Troubleshooting Tips
6
Hot Start
Preheats wash water to correct temperature.
Be sure the door is unlatched.
Slowly turn the Dial to HOT START.
Latch the door to start the cycle.
3
2
1
OFF
NORMAL WASH
HEAVY WASH
PLATE WARMER
(HEATED DRY ON)
RINSE ONLY (HEATED DRY OFF)
HOT START
OPTION
SHORT
WAS H
Heavy or Normal
Be sure the door is unlatched.
Slowly turn the Dial to the cycle you
want. Don’t turn it
past this position,
or you could accidentally miss a rinse.
Select any options.
Latch the door to start the cycle.
4
3
2
1
OFF
NORMAL WASH
HEAVY WASH
PLATE WARMER
(HEATED DRY ON)
RINSE ONLY (HEATED DRY OFF)
HOT START
OPTION
SHORT
WAS H
Short Wash (on some models)
For quickly washing loads of everyday dishes
with medium soils that have not dried on.
Be sure the door is unlatched.
Slowly turn the Dial to SHORT WASH.
Latch the door to start the cycle.
3
2
1
OFF
NORMAL WASH
HEAVY WASH
PLATE WARMER
(HEATED DRY ON)
RINSE ONLY (HEATED DRY OFF)
HOT START
OPTION
SHORT
WAS H
Using the dishwasher.
The entering water must be at least 120°F. and
not more than 150°F., for effective cleaning and to
prevent dish damage. Check the water temperature
with a candy or meat thermometer. Turn on the
hot water faucet nearest the dishwasher, place the
thermometer in a glass and let the water run
continuously into the glass until the temperature
stops rising.
Check the Water Temperature
To Next Page
Loading...
Need help?
General
