GE GSD1230 Use & Care Guide

Operating Instructions
Dial Cycles (continued)
The RINSE & HOLD cycle is for rinsing
partial loads which will be washed later.
Do not use detergent.
a. Make sure ENERGY SAVER is selected.
b. Be sure the door is unlatched.
c. Slowly turn the Cycle Indicator Dial to
RINSE & HOLD.
d. Latch the door to start the cycle.
The PLATE WARMER cycle is for warming clean
dishes and serving plates for the serving of hot foods.
The cycle will take approximately 32 minutes if selected.
a. Load clean plates and dishes to be warmed.
b. Select HEATED DRY.
c. Be sure the door is unlatched.
d. Slowly turn the Cycle Indicator Dial to
PLATE WARMER.
e. Latch the door to start the cycle.
Wash Cycles
POTSCRUBBER
NORMAL WASH
LIGHT WASH
WATER SAVER
SHORT WASH
RINSE & HOLD
Water Use
Gallons
(approx.)
10.6
9.1
7.9
6.4
7.4
3.0
Wash Cycle
Time
Minutes
(approx.)
72*
51*
51*
51*
43*
12*
Rinse Rinse
Rinse
Rinse
Main
Wash
Rinse Rinse
Cycle Sequence
Rinse
Main
Wash
Rinse
Rinse
Rinse
Rinse
Rinse
*Unextended times. These cycle times will be increased approximately 21 minutes if TEMP BOOST option is selected.
Drying Options:
HEATED DRY. Available on all wash cycles except RINSE & HOLD. Add 32 minutes to wash cycle time.
ENERGY SAVER. Drying heater is turned off. Dishes dry naturally.
Rinse
Rinse
Main
Wash
Rinse
Rinse
Rinse
Main
Wash
Main
Wash
Rinse
Rinse
Rinse
Rinse
Rinse
Rinse
Cycle Selection Chart
Rinse
5
Quiet Power
CYCLE
ON
1
2
3
4
5
6
SHORT WASH
RINSE & HOLD
START
START DELAY
(HRS)
PLATE
WARMER
(PRESS
HEATED DRY)
OFF

GE GSD1230 Specifications

General

Brand	GE
Model	GSD1230
Category	Dishwasher
Language	English