49-1000471 Rev. 1 19
CARE AND CLEANING
Care and Cleaning
Preparing for Vacation
)RUORQJYDFDWLRQVRUDEVHQFHVUHPRYHIRRGDQG
unplug the refrigerator. Clean the interior with a baking
soda solution of one tablespoon (15 ml) of baking soda
to one quart (1 liter) of water. Leave the doors open.
6HWWKHLFHPDNHUSRZHUVZLWFKWRWKH2))SRVLWLRQDQG
shut off the water supply to the refrigerator.
,IWKHWHPSHUDWXUHFDQGURSEHORZIUHH]LQJKDYHD
qualified servicer drain the water supply system (on
some models) to prevent serious property damage due
to flooding.
Preparing to Move
Secure all loose items such as shelves and drawers by
taping them securely in place to prevent damage.
When using a hand truck to move the refrigerator, do not
rest the front or back of the refrigerator against the hand
truck. This could damage the refrigerator. Handle only
from the sides of the refrigerator.
Be sure the refrigerator stays in an upright position
during moving.
Replacing the Light Bulbs
WARNING
Before replacing a burned-out light bulb, the refrigerator should be unplugged in order to avoid
contact with a live wire filament. (A burned-out light bulb may break when being replaced.)
7XUQLQJWKHFRQWUROWRWKH2))SRVLWLRQGRHVQRWUHPRYHSRZHUWRWKHOLJKWFLUFXLW
Refrigerator Compartment—Upper Light
1. Unplug the refrigerator.
2. The bulbs are located at the top of the compartment,
inside the light shield. On some models, a screw at
the front of the light shield will have to be removed.
On other models, the screw is located in the pocket
located at the back of the shield.
3. To remove the light shield, on some models, press
in on the tabs on the sides of the shield and slide
forward and out. On other models, just slide the
shield forward and out.
4. After replacing the bulb with an appliance bulb of the
same or lower wattage, replace the light shield and
screw. When replacing the light shield, make sure
that the tabs at the back of the shield fit into the slots
at the back of the light shield housing.
5. Plug the refrigerator back in.
Tabs
Your light shield will look like one of the following:
OR
Pocket
Behind the Refrigerator
Be careful when moving the refrigerator away from
the wall. All types of floor coverings can be damaged,
particularly cushioned coverings and those with
embossed surfaces.
Pull the refrigerator straight out and return it to position
by pushing it straight in. Moving the refrigerator in a side
direction may result in damage to the floor covering or
refrigerator.
When pushing the refrigerator back, make sure you
don’t roll over the power cord or icemaker supply line (on
some models).
To Next Page
Loading...
Need help?
General
Weight and Dimensions
