EasyManuals Logo

GE GTD65EBPLDG User Manual

GE GTD65EBPLDG
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
Problem Possible Causes What To Do
Dryer doesn’t start Dryer is unplugged Make sure the dryer plug is pushed completely into
the outlet.
Fuse is blown/circuit breaker Check the house fuse/circuit breaker box and replace
is tripped fuse or reset breaker. NOTE: Most electric dryers use
2 fuses/breakers.
Dryer doesn’t heat Fuse is blown/circuit breaker is Check the house fuse/circuit breaker box and replace
tripped; the dryer may tumble both fuses or reset both breakers. Your dryer may tumble
but not heat if only one fuse is blown or one breaker tripped.
Gas service is off Make sure gas shutoff at dryer and main shutoff are
fully open.
Dryer shakes or Some shaking/noise is normal. Move dryer to an even floor space, or adjust leveling legs
makes noise Dryer may be sitting unevenly as necessary until even.
Greasy spots on clothes Improper use of fabric softener Follow directions on fabric softener package.
Drying dirty items with Use your dryer to dry only clean items. Dirty items can
clean ones stain clean items and the dryer.
Clothes were not Sometimes stains which cannot be seen when the
completely clean clothes are wet appear after drying. Use proper washing
procedures before drying.
Lint on clothes Lint filter is full Clean lint screen before each load.
Improper sorting Sort lint producers (like chenille) from lint collectors
(like corduroy).
Static electricity can attract lint See suggestions in this section under Static occurs.
Overloading Separate large loads into smaller ones.
Paper, tissue, etc. left in pockets Empty all pockets before laundering clothes.
Static occurs No fabric softener was used Try a fabric softener.
Bounce
®
Fabric Conditioner Dryer Sheets have been
approved for use in all GE Dryers when used in
accordance with the manufacturer’s instructions.
Overdrying Try a fabric softener.
Adjust setting to Less Dry or Damp Dry.
Synthetics, permanent press Try a fabric softener.
and blends can cause static
Inconsistent Type of heat Automatic drying times will vary according to the type
drying times of heat used (electric, natural or LP gas), size of load,
types of fabrics, wetness of clothes and condition of
exhaust ducts.
Troubleshooting Tips
Save time and money! Review the charts on the following pages, or visit
GEAppliances.com. You may not need to call for service.
Before you call for service…
GEAppliances.com
9

Other manuals for GE GTD65EBPLDG

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GE GTD65EBPLDG and is the answer not in the manual?

GE GTD65EBPLDG Specifications

General IconGeneral
Colorwhite, diamond gray
Dryer Capactity7.4 cubic feet
Number of Cycles4
Cycle Selectionsanti-bacterial, towels and sheets, antibacterial, bulky items, damp dry, extended tumble, jeans, mixed load, my cycle, quick fluff, sanitize, towels/ sheets
Optionsextended tumble
Stackableno
Ventingtrue, vented
Temperature Settings5
Temperature Selectionshigh, medium, low, extra low, no heat
Temperature Controlyes
Delay Startyes
Child Lockno
Cycle Signalyes
Interior Lightyes
Drying Rackno
Moisture Sensor Optionyes
Steamno
Smart Homeno
Voltage240 volts
Current24 amperes
Weight and Dimensions IconWeight and Dimensions
Depth30 1/2 inches
Height46 inches
Width27 inches
Net Weight107 pounds

Related product manuals