11
GEAppliances.com
Preparing for Vacation
For long vacations or absences, remove
food and unplug the refrigerator. Move the
refrigerator control to the 1 (off) position and
clean the interior with a baking soda solution of
one tablespoon (15 ml) of baking soda to one
quart (1 liter) of water. Leave the doors open.
Set the icemaker power switch to the O (off)
position or move the feeler arm to the STOP (up)
position (depending on model) and shut off the
water supply to the refrigerator.
If the temperature can drop below freezing,
have a qualified servicer drain the water supply
system (on some models) to prevent serious
property damage due to flooding.
Preparing to Move
Secure all loose items such as grille,
shelves and drawers by taping them
securely in place to prevent damage.
Be sure the refrigerator stays in an upright
position during moving.
Replacing the light bulb.
Setting the refrigerator control to 1 (off) does not remove power to the light circuit.
5HIULJHUDWRU&RPSDUWPHQW³8SSHU/LJKW
CAUTION: Light bulb may be hot.
Unplug the refrigerator.
The bulb is located at the top of the
compartment near the opening.
Replace with an appliance bulb of the
same or lower wattage.
Plug the refrigerator back in.
To Next Page
Loading...
Need help?
General
