PREPARE FOR INSTALLATION
Inside the freezer, loosen the two mounting screws,
but do not screw them all the way out. If your model
does not have the screws already in the freezer wall,
look for two plug buttons. Remove the plug buttons
and insert the two Phillips head screws. The screws
should extend approximately 1/2″ (13mm) out
from the freezer wall.
3
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
•
CAUTION – Unplug the
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator from
its electrical outlet.
Flat blade and Phillips
screwdrivers
Pliers
TOOLS YOU WILL NEED
REMOVE THE OUTLET COVER
• Remove the outlet cover
with a flat-blade screwdriver.
2
SET POWER SWITCH TO O (off)
Set the icemaker power switch to O (off). Leave
the power switch in the O (off) position until the
refrigerator is connected to the water supply to
prevent premature operation.
4
Power
Switch
INSTALL FILL TUBE
• If the refrigerator already has a
water tube inlet on the back of the
refrigerator, go to Step 2.
• Remove and discard the white plug
from the lower left back corner of
the freezer wall.
• Go to the back of the refrigerator. Find the small
label in the upper right hand corner and peel it
off. Then discard the label.
• Peel one side of the paper away
from the water fill tube seal, slide
the seal along the tube and affix
to the back side of the water
tube inlet flange.
• Remove the adhesive
backing on the opposite side
of the water fill tube seal and
slide the tube into the hole
near the top at the back of the refrigerator. Firmly
press on the inlet to secure it to the refrigerator.
1
Hole for
wire tie
Remove
plug
(Appearance may vary)
13
Side
Back
Seal
Mounting
screws
Installation Instructions
PARTS INCLUDED
1
3
2
NO. DESCRIPTION QUANTITY
1 Water Fill Tube 1
2 Ice Fill Guide 1
3 Water Fill Tube Seal 1
ICEMAKER INSTALLATION INSTRUCTIONS
To Next Page
Loading...
Need help?
General
