To Next PageTo Next PageWhat to do if there is water on the floor behind my GE Wine Cooler?
If you find water on the floor behind your GE Wine Cooler, make sure the door is closed completely after opening, checking for any bottles that might be obstructing it. This is also normal if the unit was tilted when moving, as the drain pan above the compressor may be full following defrost. Ensure no water spills when moving the unit.
Why my GE GVS04 does not operate, but the display is lit?
This is normal if the setting is above room temperature. If wine and/or beverages are too warm, change the temperature setting to a lower one.
Why is my GE Wine Cooler too cold?
If your GE Wine Cooler is too cold, check the temperature control settings. Also, ensure the room temperature where the appliance is located is not too cold. For proper operation, the room temperature should be equal to or greater than the set temperature of the appliance.
What to do if my GE GVS04 Wine Cooler display is on but not cooling?
If your GE Wine Cooler's display is lit but not cooling, it is normal if the setting is above room temperature. If the wine or beverages are too warm, lower the temperature setting.
What to do if my GE GVS04 Wine Cooler is too warm?
If your GE Wine Cooler is too warm, especially when first plugged in, allow 12 hours for it to cool down completely. This is also normal when large amounts of wine are placed inside. Ensure the temperature control is set cold enough. If the weather is warm or you frequently open the door, try setting the temperature control one step colder. Make sure the appliance isn't too close to the wall, and always ensure the door is fully closed, checking for any bottles obstructing it.
How to fix a GE Wine Cooler that is not operating and the display is blank?
If your GE Wine Cooler isn't operating and the display is blank, first ensure the appliance is properly plugged into the outlet. If it is, check your home's circuit breaker or fuse box. A tripped breaker should be reset, and a blown fuse should be replaced.
What to do if my GE GVS04 is too cold?
If your GE Wine Cooler is too cold, check if the temperature control is set too low and adjust accordingly. The room temperature where the appliance is located may also be too cold.
How to clean rust, tarnish, or grime on GE Kitchen Appliance stainless steel doors?
To clean rust, tarnish, or grime on your GE Kitchen Appliance's stainless steel doors, use cleaners containing oxalic acid (e.g., Bar Keepers Friend Soft Cleanser). These will remove rust, lime, and other tarnish. Avoid wiping the appliance with a soiled dishcloth or wet towel. Do not use scouring pads, powdered cleaners, bleach, or cleaners containing bleach, as they can scratch and ruin the brushed finish of the stainless steel.
What to do if my GE GVS04 does not operate and the display is blank?
If your GE Wine Cooler isn't working and the display is blank, first ensure it's properly plugged into the outlet. If it is, check your home's circuit breaker or fuse box. A tripped breaker should be reset, and a blown fuse should be replaced.
Why does the motor in my GE GVS04 operate for long periods?
If the motor in your GE Wine Cooler runs for extended periods, this is normal when you first plug it in. Allow 12 hours for cooling. It's also typical after loading a large amount of wine. Ensure the door is closed properly; check for obstructions. In hot weather or with frequent door openings, this is also normal. Check that the temperature control isn't set to the coldest setting and that the appliance isn't too close to the wall.
General| Brand | GE |
|---|---|
| Model | GVS04 |
| Category | Wine Cooler |
| Language | English |
