8
Installation Instructions
OPERATION CHECKLIST
❏ Remove all items from the cooktop surface.
❏ Turn on the power to the cooktop. (Refer to your
Owner’s Manual.) Verify that all surface units
operate properly.
❏ Check that the circuit breaker is not tripped or the
house fuse is blown.
❏ Check that conduit is securely connected to the
junction box.
❏ See Owner’s Manual for troubleshooting list.
❏ NOTE TO ELECTRICIAN:
The power leads supplied with this appliance
are CSA-recognized for connections to larger gauge
household wiring. The insulation of these leads
is rated at temperatures much higher than the
temperature rating of household wiring.
The current-carrying capacity of a conductor
is governed by the wire gauge and also the
temperature rating of the insulation around
the wire.
NOTE: ALUMINUM WIRING
A. WARNING:
IMPROPER CONNECTION OF ALUMINUM
HOUSE WIRING TO THE COPPER LEADS
CAN RESULT IN A SERIOUS PROBLEM.
B. Splice copper wires to aluminum wiring using
special connectors designed and CSA-approved
for joining copper to aluminum and follow the
manufacturer’s recommended connector
procedure closely.
NOTE: Wire used, location and enclosure of splices,
etc., must conform to good wiring practice and
local codes.
F
To Next Page
Loading...
Need help?
General
