www.GEAppliances.com
The oven door must be closed and all controls set correctly for the cycle to work properly.
DELAY
START
How to Delay the Start of Cleaning
Make sure tile dock shows the correct tinle
of day.
[] Touch tile SELFCLEANpad.
[] Using the number })ads, enter the
desired clean time.
[] Touch tile DELAYSTART pad. Tile
earliest start time you can set will
appear in tile display,
[] Using tile number pads, enter tile
time of day _ou want the clean cycle
to stnrt.
[] Touch the STARTpad.
The door locks automatically. The display
will show the start time. It will not be
possible to open tile oven door/mtil tile
temperature drops below the lock
temperature and tile LOCKEDDOORlight
goes off'.
_4]/en the LOCKED DOOR light is off, open
tile door.
After a Clean Cycle
Ym mm notice some white ash in the o_en.
_4iI)e it up with a damp cloth after the
ox, en cools.
If white spots remain,remove them with a soap-
filled steel-wool pad and nnse thoroughly with a
wnegarand water mixture.
These deposits are usually a salt residue
that cannot be remoxed b'_ tile clean c_cle.
If tile o_,en is not clean aiier one clean
cycle repeat tile c)cle.
You cannot set tile oven fiw cooking tmfil
tile o_en is cool enot/gh for tile door to
tmlock.
:* While tile oven is sel6cleaning, you can
touch the CLOCK pad to display the
time of day: To return to tile clean
countdown, touch tile COOKING TIME
pad.
:_ If the shelves become hard to slide, apply
a small amotmt _ff vegetable oil or cooking
oil to a paper towel and wipe the edges of
the oven shelves with the paper towel.
3/
To Next Page
Loading...
