Installationof the range.
Read these instructions completelF and carehdlg
BEFOREYOUBEGIN
Installation of thb range must conform with local codes, or in the absence of local codes, with the
National Fuel Gas Code,ANSI Z223.1,latest edition. In Canada, installation must conform with the current
Natural Gas Installation Code, CAN/CGA-B 149.1or the current Propane Installation Code, CAN/CGA-
B149.2,and with local codes where applicable. Thisrange has been design-certified bythe American
GasAssociation according toANSI Z21.1, latest edition and Canadian GasAssociation according to
CAN/CGA-1.1latest edition.
As Mfl_ any appliance using gas and g_nerafing
heat, there are certain safety precautions you
should follow. You will find these precautions
in tile ImportantSafetylnformation sect.ion in the
flont of this manual. Read them ca_eflfllv.
IMPORTANT."Save these instructions for the local
electrical inspector's use.
NOTE TO INSTALLER:Leave these instructions
with the appliance after installation is completed.
NOTE TO CONSUMER:Keep this Owner's Manual
and Installation Instructions for future use.
NOTE,"This appfiance must be properly grounded.
FORYOURSAFETY
Oo not store or use combustible materials, gasoline or other flammable vapors and liquids in the vicinity
of this or any other appliance.
ff yousmell gas:
[] Open windows.
[] Don't touch elecuica] switches.
[] Extinguish any open flame.
[] Immediately call your gas supplier
ADDITIONAL MATERIALSYOUMAY NEED:
TOOLSYOUWILLNEED
Phillips and flat-blade screwdrivers
Pencil and ruler
:_Two pipe wrenches (one for backup)
Open-end or adjustable wrench
Nut drivers or wrenches: 3/16" and 1/4"
Gasline shut-offvalve
Pipe joint sealant or UL-approved pipe thread
tape with Teflon that resists action of natural
and LP gases
Flexible metal appliance connector (1/2" LD.)
A 5-footlength is recommended for ease of
installation but other lengths are acceptable.
Never use an old connector when installing a
new range.
*Teflon.RegisteredtrademarkofDuPont
Flare union adapter for connection to gas supply
line (3/4" or 1/2" NPTx 1/2" LD.)
Flare union adapter for connection topressure
regulator on range (1/2" NPTx I/2" I.D.)
41
To Next Page
Loading...
