GE JGBP26GEN - Page 45

❑ CONVERTING SURFME BURNERS ON
MODELS EQUIPPED WITH S~LED BURNERS (See
Step 4 if range is equipped with dual burners.)
Burnercap~
Burner Head
Bu::a
Orifice Spud
Gas Inlet Tube
L
~~~a\
—.
\
)
7-
..-—
1. Remove grates, burner caps and burner heads.
2. Remove burner bases by unscrewing the 3
small screws in each base.
~ burner
strti@t out.
DO NOT
disconnect the wires from the burner
bases unless the
cooktop needs to be raised.
3. With
7mm or 5/16” wrench (depending
on the size of your spuds), remove the 4 brass
orflce spuds.
4. Install orifice spuds
accordin to one of the
d
following diagrams (see ❑ or B ), for LP
gas or natural gas, depending on which you are
converting to.
❑ Orifice Spuds brConve~ingto U&:
LP orifice spuds are in a small plastic bag packed
with this Use and Care book.
LP orifice spuds
have a 2-digit number and the Letter “L” on
one side. Each orifice spud will also have 1 or 2
grooves on one side, denoting the location on
the range where it is to be installed.
❑ Orifice Spuds ferConVefiing to Natural Gas:
Natural gas orifice spuds have a 3-digit number
on one side. Each orifice spud will also have 1, 2
or 3 grooves on one side, denoting the location
on the range where it is to be installed.
Front of Range
(continued next page)
45
—