52
PROBLEM SOLVER
(continued)
PROBLEM POSSIBLE CAUSE
OVEN CONTROL SIGNALS • This is reminding you to enter a bake temperature (see the Baking section).
AFTER ENTERING COOK
TIME OR STOP TIME
OVEN DOOR WILL • Oven must cool below locking temperature. Do not lock the door with
NOT UNLOCK door latch except when using self-clean feature or the oven may lock.
“door” APPEARS • Self-cleaning cycle has been selected but latch handle was not moved all the
IN THE DISPLAY way to the right. Move the latch handle.
• Latch handle was moved to the right but a program other than self-cleaning
was selected. Move the latch handle to the right only when setting the
self-cleaning cycle.
OVEN NOT CLEAN AFTER • Oven controls not set properly. See Operating the Self-Cleaning Oven section.
CLEAN CYCLE
• Heavily soiled oven requires 3
1
⁄
2
to 4 hours of cleaning time.
• Heavy spillovers should be cleaned up before starting clean cycle.
CLOCK DOES NOT WORK • Range electrical plug must be securely seated in a live power outlet. Check for
blown fuse or tripped circuit breaker.
NIGHT LIGHT DOES • Fluorescent bulb is loose or defective. Adjust or replace.
NOT WORK
• Switch operating the light is broken. Call for service.
OVEN TEMPERATURE • The oven thermostat needs adjustment. See the Adjust the Oven
TOO HOT OR TOO COLD Thermostat—Do It Yourself section.
OVEN DOOR • Press the CLEAR/OFF pad. Allow the oven to cool and
ACCIDENTALLY LOCKED then unlatch the door.
WHILE BAKING
RAINBOW EFFECT IN • This is normal. It is caused by the heat treatment applied to the oven window.
THE OVEN WINDOW
(on some models)
If you need more help…call, toll free:
GE Answer Center
®
800.626.2000
consumer information service
To Next Page
Loading...
