Using the clock and timer.
Not all features are on off models.
Make sure the clock is set to the
correct time of dog.
To Set the Clock
The clock must be set to the correct time of
day for the automatic oven timing functions
to work properly. The time of day cannot be
changed during a timed baking or self-
cleaning cycle.
[] Touch the Clock pad.
[] Touch the number pads.
If number padsare not touched within one
minute after you touch the Clock pad,the
display reverts to the original setting. If this
happens,touch the Clock pad and reenter
the time of day.
[] Touch the Start pad until the time of
day shows in the display.This enters
the time and starts the clock.
Touch the number padsthe same wag you
read them. Forexample, to set !2:34, touch
the number padsl, 2,3 and 4 in that ordeE
To check the time of day when the display
is showing other information, simply touch
the Clock pad. The time of dog shows until
another pod is touched.
FqE] E] FqE] i
The timer is o minute timer only.
The Clear/Off pod does not affect
the timer.
To Set the Timer
Thetimer does not control oven operations.
Themaximum setting on thetimer is 9 hours
and 59 minutes.
[] Touch the Kitchen Timer On/Off pad.
[] Touch the number pads untilthe
amount of time you want shows in the
displag.The maximum time that can be
entered in minutes is59.Timesmore
than 59 minutes should be changed to
hours and minutes. For example, to
enter 90 minutes as 1 hour BOminutes,
touch 1,3 and 0 in that ordeE
tfyou make a mistake, press the Kitchen
Timer On/Off pad and begin again.
[] Touch the Start pad. After pressingthe
Start pad, Set disappears;this tells you
the time is counting down, although the
display does not change until one
minute has passed.
[] When the timer reaches :00, the control
will beep Btimes followed bg one beep
every 6 seconds until the Kitchen Timer
On/Offpad istouched.
The6 secondtone can be canceledby
following the steps in the Specialfeatures
of your ovencontrol sectionunder Tones
at theEnd ofo TimedCycle.
16
To Next Page
Loading...
