OPERATING THE SELF-CLEANING OVEN
(continued)
How to Set Oven for Cleaning
Quick Reminder:
The self-clean cycle will automatically begin after
“CLEAN” is displayed and the time for the clean cycle
1. Press the CLEAN pad.
is set. The words “ON” and “LOCK” will appear in the
2. Press the INCREASE or DECREASE pad
display when the door automatically locks. It will not
until the desired Clean Time appears.
be possible to open the oven door until the temperature
drops below the lock temperature and the LOCK light
If the oven is too hot and you start to set a clean
goes off.
cycle, the word “OFF” will appear in the display.
4. When the LOCK light is off, open the door.
Allow additional time for cooling before you try to
NOTE:
set the cycle.
1. Follow the directions in the Before a Clean Cycle
● You can find out when the clean cycle will be
finished by pressing the STOP TIME pad.
section.
c1
2.
CLEAN
.
.
After closing the door, press the
●
The word “door” will be displayed, the word
CLEAN pad.
“LOCK” will flash and oven control will signal if you
set the clean cycle and forget to close the oven door.
c
A fan may automatically turn on and off to cool
internal parts. This is normal, and the fan may
Press the INCREASE or
continue to run after the oven is turned off.
DECREASE pad until the
desired Clean Time is displayed.
Clean Time is normally 3 hours. You
can change the Clean Time to anytime
between 2 and 4 hours, depending on
the amount of soil in your oven.
To Stop a Clean Cycle
c1
1. Press the CLEAWOFF pad.
2. When the LOCK light goes off and the oven has
CLEAR
cooled below the locking temperature, open the door.
OFF
20
To Next Page
Loading...
Need help?
General
