GE JN322 User Manual

To Operate
Lamp Switch Models: JN322, JV322, JV332
Press for OFF and ON.
Lamp Switch Model: JV346
Rotate clockwise, first position for NIGHT LIGHT,
second position for BRIGHT LIGHT.
Fan Switch
Models: JN322, JV322, JV332
CENTER position OFF, LEFT position LOW SPEED,
RIGHT position HIGH SPEED.
Model: JV346
Rotate Clockwise, FIRST position HIGH, SECOND
position MEDIUM, THIRD position LOW.
To Maintain
Replaceable Filter
JN322, JV346 non-ducted installation
The efficiency of your hood depends upon a clean filter,
the frequency of filter replacement depends upon the type
of cooking you do; however, with average, normal usage,
replacement should be every 6 to 12 months.
NEVER OPERATE THE HOOD WITHOUT THE
FILTER IN PLACE.
When to replace the filter: JN322
The filter has distinct color stripes of indicating material on
the visible surface. It is TIME TO CHANGE when the filter
stripes have either blended together or faded completely.
Model JV346 non-ducted installations
The filter supplied with the hood does not have
indicating stripes and should be replaced after 6 months.
Replacement filters will have the indicating stripes as
described under the filter for Model JN322.
To remove: Pull down on the center of the front edge of
the filter. The filter will then slip out of the retaining tabs
on the back.
To replace:
Slip the back edge of the filter into the retaining
tabs and push the front edge up until it snaps in place.
Replace with genuine GE part: filter part number
WB02X8406.
Grease Filter “JV” models only
The efficiency of your hood depends on a clean filter.
Frequency of cleaning depends on the type of cooking you
do. BUT GREASE FILTER SHOULD BE CLEANED
AT LEAST ONCE A MONTH. NEVER OPERATE
THE HOOD WITHOUT THE FILTER IN PLACE.
To remove: Pull down on the center of the front edge of
the filter. The filter will then slip out of the retaining tabs
on the back.
To clean: Soak and then agitate in a hot detergent
solution. Light brushing may be used to remove imbedded
soil. Rinse, shake and remove moisture before replacing.
With careful handling, the filter will last for years.
If replacement becomes necessary, order the part from
your dealer.
To replace: Slip the back edge of the filter into the
retaining tabs and push the front edge up until it snaps
into place.
Hood
Clean grease laden surfaces of the hood frequently.
Use warm detergent solution. About 1 tablespoon of
ammonia may be added to the water. TAKE CARE TO
NOT COME IN CONTACT WITH FILTERS AND
OTHER NON-ENAMELED SURFACES. The hood
shell can be washed, rinsed and dried with a soft cloth.
Motor and Fan
To Clean Motor and Fan
1. DISCONNECT THE HOOD POWER SUPPLY AT
THE HOUSEHOLD DISTRIBUTION PANEL BY
REMOVING THE FUSE OR SWITCHING OFF
THE CIRCUIT BREAKER.
2. Remove the filter.
3. Wipe the fan blade and motor with cloth, dampened
only in ammonia and warm water solution.
4. Replace the filter.
5. Reconnect the hood power supply.
CAUTION: Be certain when cleaning the hood
surfaces you do not touch the lamp bulb with moist
hands or cloth. A warm or hot lamp bulb may break
if touched with a moist surface. ALWAYS let lamp
cool COMPLETELY before cleaning around it.
3
Vents
(JN322 & JV346)
Lamp switch Fan switch Trim

GE JN322 Specifications

General

Brand	GE
Model	JN322
Category	Ventilation Hood
Language	English