EasyManua.ls Logo

GE JVX5360 - User Manual

GE JVX5360
26 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Write the model and serial
numbers here:
Model # _________________
Serial # _________________
You can find them on a label
on the inside of the hood.
RANGE HOODS
29-6094 10-16 MCC
SAFETY INFORMATION ............3
USING THE HOOD
Controls ................................5
Chef Connect ...........................6
CARE AND CLEANING
Filters ..................................7
Surfaces ................................8
Lights ..................................8
INSTALLATION INSTRUCTIONS ..9
TROUBLESHOOTING TIPS ........20
WARRANTY ........................ 21
ACCESSORIES .....................22
PRODUCT REGISTRATION ........23
CONSUMER SUPPORT ............26
JVX3240
JVX3300
JVX5300
JVX5360
PVX7300
PVX7360
OWNER’S MANUAL
& INSTALLATION
INSTRUCTIONS
GE is a trademark of the General Electric Company. Manufactured under trademark license.

Table of Contents

Questions and Answers

  • C
    Carol AndersonSep 23, 2025
    What to do if my GE Ventilation Hood fan is making noise and not circulating air well?
    • D
      danielblackSep 23, 2025
      If the GE Ventilation Hood fan is making loud or abnormal airflow noises, or if it seems to circulate air slower than usual, several factors could be at play. Start by checking for any obstructions blocking the vent. Ensure that the damper blade on the wall or roof cap swings freely and is in its original position. A dirty metal grease filter or charcoal filter (if present) can also cause these issues, so clean the metal grease filter and replace the charcoal filter. Finally, ensure sufficient makeup (replacement) air is available, as required by local building codes for exhausting appliances to operate correctly.
  • D
    danielle22Aug 23, 2025
    Why is my GE Ventilation Hood making a loud noise?
    • D
      dannyhatfieldAug 23, 2025
      If your GE Ventilation Hood is making loud or abnormal airflow noise, it might be due to the wrong duct size used during installation. Using a smaller duct pipe can reduce venting efficiency. Minimize the duct run length and the number of transitions and elbows. Note that GE Appliances service technicians cannot correct this issue if the hood was installed improperly.
  • C
    cristianjonesAug 25, 2025
    How to fix a GE JVX5360 Ventilation Hood when the damper blade is not open?
    • M
      Michael LiAug 26, 2025
      The damper blade on your wall or roof cap might not be open. Make sure the damper swings freely and adjust it to its original position if the damper blades have flipped over, preventing it from fully opening.
  • A
    Ashley LozanoAug 26, 2025
    What to do if the GE Ventilation Hood fan/light does not turn on?
    • C
      Cathy FryAug 26, 2025
      If the fan or light on your GE Ventilation Hood isn't working when you press the button, a house fuse may have blown, or a circuit breaker may have tripped. Replace the fuse or reset the circuit breaker to solve this issue.
  • D
    Dominique RollinsAug 27, 2025
    Why does my GE Ventilation Hood need makeup air?
    • L
      Lonnie AlvarezAug 28, 2025
      Insufficient makeup (replacement) air is required for exhausting appliances to operate to rating. Check with local building codes, which may require or strongly advise the use of makeup air. Visit GEAppliances.com for available makeup air solutions.
  • M
    Melanie JamesSep 18, 2025
    What causes early light failure in a GE JVX5360 Ventilation Hood?
    • H
      hillemilySep 18, 2025
      If the light in your GE Ventilation Hood fails early, the light wattage might be too high. Replace it with a bulb of the correct wattage.
  • O
    oliverpamelaSep 15, 2025
    How to fix a GE JVX5360 Ventilation Hood fan that doesn't operate when pressing the speed buttons?
    • S
      Stephen ParsonsSep 15, 2025
      If the fan on your GE Ventilation Hood doesn't work when you press the Lo, Med, or Hi buttons, the blower connector might be loose or not plugged in. Disconnect power to the unit, remove the filters, and check the blower. If the connector plug is loose or dangling, plug it in securely.
  • G
    Gregg DiazSep 16, 2025
    Why is my GE JVX5360 Ventilation Hood making loud airflow noise?
    • M
      Matthew WilsonSep 16, 2025
      Loud or abnormal airflow noise may be due to the wrong duct size used during installation. Using smaller duct pipe will cause reduced venting. It is important to minimize the duct run length and number of transitions and elbows. GE service technicians cannot correct this issue if installed improperly.
  • K
    Kenneth LewisSep 6, 2025
    Why is my GE JVX5360 so loud?
    • F
      floydaaronSep 6, 2025
      If your GE Ventilation Hood is making loud or abnormal airflow noises, it might be due to the wrong duct size being used during installation. Using a smaller duct pipe restricts venting. Try to minimize the duct run length and the number of transitions and elbows. Note that GE Appliances service technicians cannot correct this issue if the hood was improperly installed.
  • C
    Christopher ReedSep 3, 2025
    Why does my GE JVX5360 fan keep cycling on and off?
    • S
      Scott NielsenSep 3, 2025
      If your GE Ventilation Hood fan is constantly turning off and on, it's likely that the motor is overheating. This can be harmful, so you should address it promptly. Clean the metal grease filter and replace the charcoal filter if one is present. Refer to the Care and Cleaning section of the manual for detailed instructions.

GE JVX5360 Specifications

General IconGeneral
TypeUnder Cabinet
Width36 in
Fan Speeds3
LightingIncandescent
Control TypePush Button
Height6 in
Number of Bulbs2
ColorStainless Steel
MaterialStainless Steel
Ventilation TypeDucted

Related product manuals