ww_.GEAppliances.com
The oven door must be closed and all controls must be set correctly for the cycle to work properly.
ii!!iiii!iiii!i
How to Delay the Start of Cleaning
[] Press the SELFCLEANLOISTDpad
once fbr a 4-hour clean time or
twice for a 3-hour clean time.
A 3-hour self-clean time is
recommended for use when
cleaning small, contained spills. A
self:clean time of 4 hours or longer
is recommended for a dirtier oven.
[]
Ifa time other than 4 hours or
3 hours is needed, use tile number
pads and enter the desired clean
tilne.
You can change the clean time to any
time between 3 hours and 5 hours,
depending on how dirty your oven is.
[] Press the DEDIFSrART pad.
[] Using the number pads, enter tile
time of day you want the clean cycle
to start.
[] Press tile STARTpad.
The door locks automatically. The display
will show the start time. It will not be
possible m open the oven door until
tile temperature drops below the lock
temperature and the LOCKEDlight
goes off.
When the LOCKEDlight goes off; you will
be able open the door.
After a Clean Cycle
You may notice some white ash in tile
oven. Wipe it up with a damp cloth after
the oven cools.
tfwhitespotsremain,removethemwitha
soap-filledsteelwoolpadandrinsethoroughly
witha vinegarandwatermixture.
These deposits are usually a salt residue
that cannot be removed by tile clean
cycle.
If tile oven is not clean after one clean
cycle, repeat the cycle.
/}55You cannot set tile oven _br cooking
until the oven is cool enough for the
door to unlock.
/})5While the oven is sel_'leaning, you
can press tile CLOCKpad to display
the time of day. To return to tile
clean countdown, press the SELF
CLEANLO/STDpad.
/_)5ffthe racks become hard to slide, apply
a small anmunt of cooking oil to a
paper towel mad wipe tile edges of"the
oven racks with tile paper towel.
17
To Next Page
Loading...
Need help?
General
