ww_. GEAppliances.com
Possible Causes What ToDo
The oven temperature is • Allow tile oven to cool and reset tile controls.
too high to set a self-clean
operation.
Oven controls improperly set. • See the Using the self-cleaning oven section.
This is the sound of the • This is normal.
metal heating and cooling
during both the cooking and
cleaning functions.
Excessive soil. • Press the CLEAR/OEFpad. Open the windows to
rid the room of smoke. Wait until the LOCKED light
goes off. Wipe tip the excess soil and reset the clean
cycle.
Oven too hot. • Allow the oven to cool below locking temperature.
Oven controls not properly set. •SeetheUsingtheself-cleaningovensection.
Oven was heavily soiled. • Clean up heavy spillovers before starting tile clean
cycle. Heavily soiled ovens may need to sell:clean
again or for a longer period of time.
The self-clean cycle has been • Close the oven door.
selected but the door is not
close
The oven door is locked • Press the CLEAR/OFFpad. Allow the oven to cool.
because the temperature
inside the oven has not
dropped below the
locking temperature.
You have a function • Press the CLEAR/OFFpad. Put the oven back into
error code. operation.
If the function code repeats. • Disconnect all power to the range for at least 30
seconds and then reconnect powen If the timction
error code repeats, call for service.
29
To Next Page
Loading...
Need help?
General
