38
Failure Codes
The oven may stop operating but not give an
F code on the display immediately. F codes are
stored in memory until the same fault occurs two
consecutive times. After that, the F code will be
displayed.
F codes can be recalled by pressing together:
TIMER, CLOCK, and 9 (or MIN DOWN).
While displayed, pressing 8 and 6 (or MIN UP and
HR DOWN) together will clear them. A fault must
exist continuously for 5 minutes before an F code
is recorded (F2, F8 are sooner).
edoCeruliaFgninaeMnoitcerroC
-0F-yekFFOdetrohS cinortcelerolenapyekhtiwsimelborpfienimreteD
dnaelbacnobbirgnitcennocsidyb)COE(lortnocnevo
.nepoebdluohS.41ot31snipelbactalfgnirusaem
.yekFFOgnisserpelihwsmho051-001ebdluohS
-2F-erutarepmetrevO
ybderusaemsaytivacnevoedisnI.1
rodehctalnuF°056revorosnes
ro,dehctalF°519
ro,dellatsnafgnilooC.2
wolley(tatsomrehtkcolroodnepO.3
evobaerutarepmetnehwylno)sdael
.F°006
z
.yalerecalper-stcatnocyalerdedleW
z
.ecalperroraelc-dekcolbrodellatsnafgnilooC
z
.tinuforaerotwolfriA
z
.srotcennoc/sdaelrosnesnevoniecnatsiserhgiH
-3F-rosnesnevonepO
z
.rewoptcennocsiD
.COEmorfssenrahrosnestcennocsiD
ebot)sdaeletihw(ecnatsiserrosneserusaeM
repsmho2htiwerutarepmetmoortasmho0011
.egnahceerged
z
dabatonfislanimretssenrahdegamadrofkooL
.rosnes
-4F-rosnesnevodetrohS
z
.rewoptcennocsiD
.COEmorfssenrahrosnestcennocsiD
ebot)sdaeletihw(ecnatsiserrosneserusaeM
repsmho2htiwerutarepmetmoortasmho0011
.egnahceerged
z
dabatonfislanimretssenrahmorfrosnesetarapeS
.rosnes
-7F-yekTRATSdetrohS .COErolenapyekhtiwsimelborpfienimreteD
-8F-eruliaftfihsatadMORPEE.COEecalper,detaeperfI
-9F-evobanevoelihwsllatsnafgnilooC
nitatsomrehtkcolroodnepo-F°056
sdaelwolley
.aeraCOEotwolfriaronafgnilooC
-FF-tiucricytefasrotomhctalfossoL.COEecalpeR
To Next Page
Loading...
