EasyManuals Logo

GE JTP35 Installation Instructions

GE JTP35
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
C []
awer
On
le or
a
For JKS10, JKP30, JKP35, JKPS5, JKPT0, JKPT5, PK916, PK956, ZEK938,
ZEKg58 models only.
SingJe 27" (68.6 cm)
Oven Over
a Warming Drawer
Double 27" (68.6 cm)
Oven Over
a Warming Drawer
Per
Warming
Drawer
Requirement
, Anti-Tip Block Against
Rear Wa_[ Per Warming
Drawer Requirement
2" (5.t era)
Min.
NOTE: Install the
oven only with
specific modets
listed on the label
located on top of
the oven.
1" (2.5 cm) Min. Above Toekick or
Adjust to Oven installation Height
NOTE: Additional clearances between cutouts
may be required. Check to be sure the oven
supports above the Warming Drawer location
do not obstruct the required interior depth and
height.
Anti-Tip B_ock
Against Rear
Wal_ Per
Warming
Drawer
Requirement
Per Warming
Drawer
Reql
1" (2.5 cm) Min. Above Toekick
o When installing a Warming Drawer below
a single or double oven, a separate 120V,
60 Hz, properly grounded receptacle must
be installed. Refer to installation instructions
packed with the Warming Drawer for
specific installation requirements.
7

Other manuals for GE JTP35

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GE JTP35 and is the answer not in the manual?

GE JTP35 Specifications

General IconGeneral
BrandGE
ModelJTP35
CategoryOven
LanguageEnglish

Related product manuals