PROBI,EM P()SSIBI,E CAUSE
"'PROBE" APPEARS
ON DISPLAY
"Error" APPEARS
ON DISPLAY
FLOOR OF THE
OVEN, tS WARM,
EVEN WHEN THE
OVEN HAS NOT
BEEN USED
*Temgerature probe is missing or not plugged in securely when using C(_lking
functions thatrneasure food temperature.
. Temperature probe is inserted for a program that does not use the probe.
• During AUto Cook; Auto Reheat or Popcorn prograin, the door was opened before
steam could be detected, or steam was not detected in maximum lime.
• No steam was detected by sensor within hmr minutes and 10 seconds after start of
Popcorn program.
, The cooktop lamp is located directly below the oven floor. When the lamp is on,
the heat it produces makes the twen floor get warm. This is normal.
All these things are normal with your microwave oven:
•Steam or vapor escaping Ironl
around the door.
• IAghl reflection uround rio+oror
oulcr c_tsc.
• l)inmlin{_ oven li{_hl and chun{_c
in hlowl2i _Ol_llid Ilili\,' i)l.'t.'tir while
opel'alinlz at pow'c'r Ic'\cl_ olhcr
than high.
• Dul I thuinpi 11: _otind _rh i lc oven
is operating.
• Some TV- Radio interference
might he ilot iced whilc tlSi 11:
your microwave oven. It's similur
to the intcrl'crcncc Catisctl by
(){ her snlill I apt)l i;.llll_'c'_>lind th)c's
1101indicuie aproblem w ilh
yOtll" ov0n.
Ifyou need niore help.., call, toll free: (;E Answer Center <''/ 800.626.2000 / consumer information service
45
To Next Page
Loading...
Need help?
General
