GE JX2127 User Manual

Installation
Instructions
Built-In TrimKits
JX2127andJX2130
Questions?Call GEAnswer Centerat 800.626.2000or Visitore-X_bsite_,t:www.GEAppliances.com ]
BEFORE YOU BEGIN
Read these instructions completely and carefully.
• IMPORTANT - S_,,'ethese
instructions ti)r local inspector's use.
• IMPORTANT - Obsei.e_,ll
governing codes and ordinances.
• Note to Installer - Be sure to leave these
instructions with the Consun]er.
• Note to Consumer - Keep these instructions
ti)r fllture reterence.
• For easier installation and peisonal satet,i, we
reconnnend that two people install this microwave oven.
" Unplug the microwave ()veil beti)re attempting
installation of this kit.
FOR YOUR SAFETY:
A WARNING - Be*,iebeginning the
installation, switch power off at service panel and lock
tile service disconnecting means to prevent power
fl'om being switched on accidentally. When the service
disconnecting means cannot be locked, securely thsten
a i)r()minent warning device, such as a tag, to the
service panel.
TOOLS YOU WILL NEED
#2Phillipsscrewdriver
Pencil
Awl or punch
Drill with 7_64Hbit or#35
Scissors(optional) Tapemeasure
READ CAREFULLY.
KEEP THESE INSTRUCTIONS.
Skill level - Installation of this appliance requires basic
mechanical and electrical skills.
• Completion time - 1-3 hours
• Proper installation is the responsibility of the installer,
" Product tailure due to imi)roper installation is not
covered under the Warranty.
This kit is UI, listed for installation alone or over
an) General Electric/Hotpoint/RCA single electric
wall OX ell.
PARTS mNCLUDED
PART QUANTITY
Trim Frame 1
Bottom Duct 1
Top Bracket 1
Phillips Round-Head 24
Screws (22 required
for installation)
Phillips Flat-Head 5
Screws (4 required for
installation)
Anti-Tip Bracket 1
Bottom Bracket 1
Template 1

GE JX2127 Specifications

General

Brand	GE
Model	JX2127
Category	Kitchen Appliance Accessories
Language	English

Summary

Before You Begin Installation

Safety Precautions for Installation

Tools Required for Installation

Cutout Dimensions for Installation

Install Bottom Bracket and Duct

Assemble Bottom Bracket and Duct

Assemble the bottom bracket and duct using screws to prepare for microwave installation.

Attach Bottom Duct to Microwave

Secure the bottom duct to the underside of the microwave oven with screws.

Install Anti-Tip Bracket

Position Anti-Tip Bracket

Mark the location for the anti-tip bracket on the cabinet floor using a template.

Secure Anti-Tip Bracket

Drill holes and fasten the anti-tip bracket to the cabinet floor with screws.

Install Microwave Oven into Cabinet

Slide Microwave into Cabinet

Carefully slide the microwave oven into the cabinet opening, engaging the anti-tip bracket.

Center and Secure Microwave

Center the microwave in the opening and secure the bottom duct to the cabinet.

Install Top Bracket

Position Top Bracket

Place the top bracket on the microwave, aligning tabs with the oven's sides.

Attach Top Bracket to Cabinet

Drill pilot holes and secure the top bracket to the cabinet with screws.

Install Trim Frame

Attach Trim Frame

Place the trim frame over the microwave and snap spring clips into the top bracket.

Secure Trim Frame

Fasten the trim frame to the microwave using flat-head screws from the inside.

Final Steps and Power Restoration

Replace Loose Items

Replace any removed items inside the microwave and manage extra screws.

Restore Power

Replace the house fuse or close the circuit breaker to restore power.