GE LED 100L C9 - User Manual

LED 100L C9 ssembl Instructions
ITE No.97775LO
Assembly Parts
①
Assembly
Tear off dotted
lines on both side
as shon.
②
Assembly
③
Assembly
Insert nob into
hole as shon.
④ Assembly Complete 1.Carefully remoe the bladed plug from the opening
on the side of the spool.
2.ith one hand gripping the center handle, use the
nob to unreel the to light string sets.
3.Remoe the end connector from the opening on
the side of the spool.
4.At seasons end, place the end connector through
a slotted side opening in the spool and reel both light
string onto the spool as noted in step 2.
Printed in China 2022
A . B . C :

Summary

Assembly Parts

Assembly Steps

Step 1: Initial Preparation

Tear off dotted lines on both sides of the spool as shown in the diagram.

Step 2: Unreeling Light Strings

Grip the center handle and use the knob to unreel the two light string sets.

Step 3: Knob Insertion

Remove the end connector and insert the knob into the designated hole.

Step 4: Assembly Complete and Storage

Place end connector through a slotted opening and reel strings for storage.

GE LED 100L C9 Specifications