Installation Instructions
[] CONNECTING THE REFRIGERATOR
TO THE HOUSE WATER LINE (cont.)
[] If you are using copper tubing, insert
the end of the tubing into the refrigerator
connection, at the back of the refrigerator,
as far as possible. While holding the tubing,
tighten the fitting.
If gou are using GE SmartConnect TM tubing,
insert the molded end of the tubing into
the refrigerator connection, at the back
of the refrigerator, and tighten the compression
nut until it is hand tight. Then tighten one
additional turn with a wrench. Overtightening
mag cause leaks.
[] Fasten the tubing into the clamp provided to
hold it in position. You mag need to prg open
the clamp.
Ferrule 1/4"
(sleeve) Compression
Refrigerator
Connection
SmartConnedY
Tubing
[] PLUG IN THE REFRIGERATOR
See the grounding information attached to the
power cord.
[] TURN ON THE WATER SUPPLY
Turn the water on atthe shutoff valve
(house water supplg) and check for ang leaks.
21
To Next Page
Loading...
