Installation Instructions
I_l LEVEL THE FREEZER DOOR
[] Locate the height adjuster in the freezer dooE
Slightlg loosen the four Phillips-head screws
from the door on each side (right and left).
[] Loosen the controller screw with a Phillips-head
screwdriver to adjust the level.
I_l LEVELTHE FREEZERDOOR (cont.}
[] Find the best position to align the door slope.
Example: The slope is about
2 mm as shown below.
Slope t__
Reference
Plane
m
Rotate the height adjuster to +2.0
to reduce the door slope.
[] After adjustment, tighten all the screws.
I_l SET THE CONTROLS
Set the controls to the recommended setting.
{ RECOMMENDED CONTROL SETT'NGS I
© ©
[] REMOVE PACKAGING
A) Remove oll tape, foam and protective
packing from shelves and drawers.
23
To Next Page
Loading...
