Safety InformationOperating InstructionsTroubleshooting TipsCustomer Service
About the water softening system.
16
B
This display segment ( ), in the following
chart, indicates an open POSITION switch. The
other indicates a closed switch. Use the
TOUCH
or
HOLD
button to manually advance the valve into each
cycle and check correct switch operation.
Press the
DATA
button again. This diagnostic display
shows the total number of recharges (top) since the
timer was connected to electrical power.
The number of days since the timer was connected to
electrical power is shown in the bottom part of the
display. If over 1999 days, a (x10) indicator shows,
meaning you must multiply the number shown by 10.
Press
DATA
once again to return the present time to
the display.
3
2
CORRECT SWITCH
DISPLAYS VALVE CYCLE STATUS
Valve in service, fill, brining,
backwash or rinse position.
Valve rotating from one
position to another.
Service: Manually Initiated Electronic Diagnostic
To Next Page
Loading...
Need help?
General
