GE PNSF39Z01 Owner's Manual

Safety InformationOperating InstructionsTroubleshooting TipsCustomer Service
Before you call for service…
24
PNSF39Z 215C1002P003 1/97
Problem Possible Causes What To Do
Resin beads showing Cracked distributor • Call for service.
up in drinking water
and sink
Troubleshooting Tips
Sounds you might hear Running water from the • This is normal.
unit into a drain
Water has air bubbles Air in system after • Will go away after it
and is cloudy installation runs for a while.
Water hard sometimes Using hot water while the • Avoid using hot water
water softening system during water softening
is regenerating system regenerations
because the water heater
will refill with hard water.
See
Automatic Hard Water
Bypass During Regneration
section.
Timer hardness number • Press and release the
SET
setting too low button until HARDNESS
shows in the display. Be
sure the number shown is
the same as the actual
grains per gallon hardness
of your water supply. See
the
Timer section if a
change in the setting is
needed.
Grains of hardness •
Water hardness can change
in your water supply over time, especially in
have increased well water. To check, have
the water tested by a water
analysis laboratory or call
your local water
department. Adjust the
hardness number setting
as needed.

GE PNSF39Z01 Specifications

General

Brand	GE
Model	PNSF39Z01
Category	Water Dispenser
Language	English