Specifications/Dimensions
Rated Capacity*
Amount of high capacity resin (lbs/cu. ft)
Resin tank nominal size (in., dia. x height)
Service flow rate (gpm) (see rating label on softener)
Water supply maximum hardness (gpg)
Water supply maximum clear water iron (ppm) **
Water pressure limits (min.-max. psi)
Pressure drop at rated service flow (psig)
Water temperature maximum (°F)
Water supply minimum flow rate (gpm)
Regeneration cycle flow rates (gpm)
Fill (flow to brine tank)
Brining
Brine Rinse
Backwash
Fast Rinse
See rating decal, located on the softener
52/1.0
10″ x 35″
10
110
6.6
20-125
15
120
3
.3
.19
.12
2.3
2.3
{
(flow to drain)
44”
36-1/4”
14”
35”
24”
3-3/8”
11-1/2”
INLET - OUTLET
INLET
OUT
Model GE Profile Performance PNSF39Z
11
This system conforms to WQA S-100-98 for specific capacity claims as verified and substantiated by test data.
* Testing was performed using pellet grade sodium chloride as the regenerant salt.
** Extent of iron removal may vary with conditions. Use of Diamond Crystal® Red•Out® or Super Iron Out® will improve iron removal. Refer to
Cleaning Iron Out of the Water Softening System
section.
To Next Page
Loading...
