GE Profile 22 - Performance Data Sheet

Performance Data Sheet
SmartWater Filtration System-GE®MSWF Cartridge
This system has been tested and certified in filter model GE MSWF according to NSF/ANSI Standards 42 and 53 for reduction of the substances listed below.
The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water
leaving the system, as specified in NSF/ANSI Standards 42 and 53.* (Safety factors built in for unmetered usage.)
Standard No. 42: Aesthetic effects
Parameter , USEPAMCL
Standard No. 53: Health effects
i
Parameter USEPAMCL
1NTU....
99.95%Reduction
0.010mg/L
0.010mg/L
0.002mg/L
0.002rng/L
0.0002rng/L
0.003mg/L
0.070mg/L
0.003mg/L
_n n 0.005mg/L
0.040mg/L
0.075mg/L
99%Reduction
l,fluent Challenge Effluent % Reduction
Concentration _ Average Maximum ' Average Maximum
2.0rng/L + 10% 0.06rng/L 0.i0 rng/L 97% 9.1%
at least 10,000particles/ 408,333 670,000 95.5% 89.4%
mL
Influent Challenge ' Effluent
Concentration
11 ± 1NTU....
Minimum 50,000L
0.15 mg/L± 10%
0.15 mg/L± 10%
0.006mg/L± 10%
0.006rng/L ± 10%
0.002rng/L ± 10%
0.009mg/L ± 10%
0.210mg/L ± 10%
0.015mg/L± 10%
0.015mg/L± 10%
0.080mg/L ± 10%
0.225mg/L ± 10%
107to 10 Bfibers/L;
fibers > 10pm in length
Average Maximum
0.38 NTU 0.5 NTU
< 1#/L 4#/L
< i ppb < i ppb
3.1ppb 9.0ppb
0.34ppb 0.7 ppb
0.66 ppb 1.5ppb
< 0.02ppb <0.02 ppb
< 0.5ppb <0.05 ppb
7.7ppb 35ppb
< i ppb < i ppb
< 0.5 ppb < 0.5 ppb
< i ppb i ppb
< 0.5ppb < 0.5ppb
<0.17 MF/L < 0.17 MF/L
*Tested using pressure of 60 psig; pH of 7.5± 0.5; temp of 68o ± 5°F (20° ± 2.5°C).
**Measurement in Particles/mL Particles used were 0.5 i microns.
***Based on the use of Cryptosporidium parvum oocysts.
.... NTU-Nephelometric Turbidity Units
Caparity 300 gallons (1,135 liters). Conta minant red uction determined by NSFtesting.
Min: RequiredReduction
->50%
->85%
% Reduction ' MaX:Peimissible
Average
96.5%
>99.99%
99.3%
98.0%
94.0%
88.4%
>99.0%
>93.9%
96.0%
>92.9%
> 96.8%
> 98.7%
>99.7%
>99%
Maximum
95.4%
> 99.99%
99.3%
95.5%
89.6%
73.7%
>99.0%
>9¢3%
82.0%
>92.9%
> 97.0%
>98.7%
> 99.8%
> 99%
Product Water
0.5 NTU
99.95%
0.010mg/L
0.010mg/L
0.002mg/L
0.002rng/L
0.0002 rng/L
0.003mg/L
0.070mg/L
0.003mg/L
0.005mg/L
0.040mg/L
0.075mg/L
99%Reduction
Application Guidelines/Water Supply Parameters
It is essential that the manufacturer's recommended installation, maintenance and filter replacement requirements be carried out for the product to perform asadvertised.
Seeinsert for Warranty information.
Operating Specifications
• Pressure requirement: 40-120 psi (2.8-8.2 bar), non-shock
• Temperature: 33-100°F (0.6-38°C)
• How rate: 0.9 gpm (3.14 Ipm)
General Installation/Operation/Maintenance Requirements
• Hush new cartridge at fuil flow for 4-1/2 gallons (about five minutes)to purge
trapped ain
• Replace cartridge when flow becomes too slow.
• Protect from freezing by removing filter cartridge when temperatures are
expected to drop below 40°F (4.4°C). Do not install systems in areas where
ambient temperatures may go above 100°F or below 40°R Do not install
on a hot water supply.
Special Notices
• Installation instructions are included with the product when shipped.
• This drinking water system must be maintained according to manufacturer's
instructions, including replacement of filter cartridges.
• Do not use with water that is microbiologicaliy unsafe or of unknown quality with-
out adequate disinfection before or after the system. Systems certified for cyst
reduction may be used on disinfected water that may contain filterable cysts.
• Thecontaminants or othersubstancesremovedor reducedbythis water
treatment systemare not necessarilyinyour water.
• Checkforcompliancewith the applicablestate and locallawsand regulations.
• Notethat whilethe testingwas performedunderstandardlaboratoryconditions,
actual performance mayvary.Systemsmust beinstalledand operated in
accordancewith manufacturer'srecommended proceduresandguidelines.
• Installationand use MUSTcomplywith allstateand local plumbingcodes.Donot
installif water pressureexceeds120psi.Ifyour water pressureexceeds80psi
(552kPa),you shouldinstall a pressure-limitingvalve.Contacta plumbing
professionalifyou areuncertain how to checkyour water pressure.
• Donot install wherewater hammer conditionsmayoccur.Ifwater hammer
conditionsexistyou must installawater hammer arrester.Contacta plumbing
professionalifyou areuncertain how to checkfarthis condition.
• Wherea backflowpreventiondeviceisinstalledon a watersystem,a devicefar
controllingpressuredue tothermal expansionmust beinstalled.
Forconditionsof use,healthclaims certified bythe CaliforniaDepartment of Public
Health,andreplacements,seeperformancedata sheet.CaliforniaDepartment
ofPublicHealthCertification#06-1834.Thecontaminants or othersubstances
removedorreducedbythiswater filter arenot necessarilyinallusers'water.
Tested and Certified by NSF International against ANSI/NSF Standards 42 and 53 in model GE MSWF for the reduction of:
Standard No. 42: Aesthetic Effects
• Chemical
- Chlorine Taste and Odor
• Mechanical Filtration
- Particulate Reduction,Class I
GE
Appliances
Appliance Park
Louisville, KY40225
geapplianceparts.com
Standard No. 53: Health Effects
• Chemical Reduction
- Atrazine Reduction
- Enddn Reduction
- Benzene and Carbofuran Reduction
- 1,4 Dichlorobenzene and
2,4-D Reduction
- Leadand Lindane Reduction
- Mercury and Toxaphene Reduction
• Mechanical Filtration
- Cyst and AsbestosReduction_
REPLACEMENT ELEMENT
EPA#10350-MN-005
© 2010 GeneralElectric Company PC61577C
42