Performance Data Sheet (onsome models)
SmartWater FiltrationSgstem-GE ® MWF Cartridge
Thissgstem has been testedand certifiedinfiltermodel GE MWF according to NSF/ANSI Standards 42 and 53 farreductionofthe substances listedbelow, The
concentrationof the indicatedsubstances inwater enteringthe sgstem was reduced to a concentrationlessthan or equal to the permissiblelimitforwater
leavingthe sgstem, as specifiedinNSF/ANSI Standards 42 and 53.*(Safetgfactorsbuiltinforunmetered usage)
Standard No. 42: Aesthetic effects
Substance
Reduction Average Influent
2.0 mg/L
7,833,333 pts/mL
NSFSpecified Challenge Average %
Concentrat on UReduct on
2.0mg/L _+I0% !97.5%
_,_particles/mL 199.7%
Average Product
Water Concentration
0.05 mg/L
18,617 pts/mL
Max Permissible Product { NSF Reductio n 1 NSF Test
Water Concentration URequirements HReport
N/A
N/A
Standard No. 53: Health effects
Substance
Reduction
147,5000 cysts/L
47 MF/L
0.016 mg/L
0.152 mg/L
0.148 mg/L
0.0058 mg/L
0.0061 mg/L
Average %
Reduction
99.99%
>99%
NSFSpecified Challenge
Concentration
Minimum 50,000 cysts/L
107to 1_ fibers/L; fibers
reater than lO
I0%
0.015 mg/L_+ I0%
_L_+I0%
I0%
0.15 mg/L_+ I0%
0.15 mg/L_+ I0%
tL _+I0%
0.006 mg/L _+10%
0.006 mg/L _+10%
_L_+10%
0.015 mg/L_+ I0%
0.015 mg/L_+ I0%
_L_+10%
e Product
Water Concentration
cyst/L
<I MF/L
94.5%
96.7%
98.7%
95.6%
99.3%
99.3%
99%
93.2%
93.2%
99.7%
96.6%
93.2%
99.5%
0.0005 mg/L
0.001 mg/L
0.001 mg/L
0.0004 mg/L
0.0004 mg/L
Max Permissible Produ
Water Concentration
N/A
N/A
0.005 mg/L
0.010 mg/L
0.010 mg/L
0.002 mg/L
0.002 mg/L
0.015 mg/L 0.0005 mg/L 0.005 mg/L
0.015 mg/L 0.001 mg/L 0.003 mg/L
NSF Reductio
_>99.95%
_>99%
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
NSFTest
Report
J-00077721
J-00077707
J-00077708
J-00077717
J-00077718
J-00082185
J-00077722
J-00077723
J-00077726
J-00077727
J-00077728
J-00077729
J-00082184
J-00077730
J-00077705
*Based on the use of Cryptosporidium parvum oocysts
Capacity 300 gallons (1,135 liters). Contaminant reduction determined by NSF testing.
Application Guidelines/Water Supply Parameters
Service Flow Water Pressure
Water SU! Water Temperature
It is essential that the manufacturer's recommended installation, maintenance and filter replacement requirements be carried out for the product to perform as advertised.
See Installation Manual for Warranty information.
Operating Specifications
• Pressure requirement: 40-120 psi (2.8-8.2 bar), non-shock
• Temperature: 33-100°F (O.6-38°C)
• Flow rate: 0.5 gpm (1.9 Ipm)
General Installation/Operation/Maintenance Requirements
• Hushnew cartridge atfullflow for 1-1/2gallons(aboutthree minutes)to purge
trapped air.
• Replacecartridge when flow becomes too slow.
• Protect from freezing by removing filter cartridge when temperatures are
expected to drop below 33°F(1°C),Do not install sgstems in areas where
ambient temperatures mag go above 100°F or below 40°F.Do not install
on a hot water supplg.
Special Notices
• Installation instructions are included with the product when shipped.
• This drinking water sgstem must be maintained according to manufacturer's
instructions, including replacement of filter cartridges.
• Do not use with water that is microbiologicallg unsafe or of unknown qualitg
without adequate disinfection before or after the sgstem. Sgstems certified for
cgst reduction mag be used on disinfected water that mag contain filterable cgsts.
• The contaminants or other substances removed or reduced bg this water
treatment sgstem are not necessarilg in gour water.
• Check for compliance with the applicable state and local laws and regulations.
• Note that while the testing was performed under standard laboratorg conditions,
actual performance mag varg. Sgstems must be installed and operated in
accordance with manufacturer's recommended procedures and guidelines.
• Installation and use MUST complg with all state and local plumbing codes. Do not
install if water pressure exceeds 120 psi. If gour water pressure exceeds 80 psi
(552 kPa), gou should install a pressure-limiting valve. Contact a plumbing
professional if gou are uncertain how to check gout water pressure.
• Do not install where water hammer conditions mag occur. If water hammer
conditions exist gou must install a water hammer arrester. Contact a plumbing
professional if gou are uncertain how to check for this condition.
• Where a backflow prevention device is installed on a water system, a device for
controlling pressure due to thermal expansion must be installed.
Tested and Certified bg NSF International against ANSI/NSF Standards 42 and 53 in model GEMWF for the reduction of:
Standard No, 42: Aesthetic Effects
• Chemical
Chlorine Taste and Odor
• Mechanical Filtration
Particulate Reduction, Class I
GE
Appliances
Appliance Park
Louisville, KY/40225
geapplianceparts.com
Standard No. 53: Health Effects
• Chemical Reduction
Atrazine Reduction
Endrin Reduction
Benzene and Carbofuran Reduction
1.,4 Dichlorobenzene and
2,4 D Reduction
Lead and Lindane Reduction
Mercurg and Toxaphene Reduction
• Mechanical Filtration
Cgst and Asbestos Reduction
REPLACEMENT
ELEMENT
© 201.0 GE Compang PC61.278B
43
To Next Page
Loading...
