Consumer SupportTroubleshooting TipsOperating InstructionsSafety Instructions Installation Instructions
7
Preparing to install the refrigerator. GEAppliances.ca
Read these instructions completely and carefully.
Do not install the refrigerator where the temperature will go below 50°F (10°C) because it will not
run often enough to maintain proper temperatures.
Install it on a floor strong enough to support it fully loaded.
Do not install it closer than 5” (13 cm) next to a range.
Do not install it in a recessed area.
Do not build in the refrigerator.
Refrigerator Location
Allow the following clearances for ease of installation and proper air circulation.
Sides 1/2” (13 mm)
Top 2” (51 mm)
Back 2” (51 mm) from the rear cabinet surface to the wall
Clearances
Leveling Legs (on some models)
Adjustable legs
at the front corners of the refrigerator should be set so the
refrigerator is firmly positioned on the floor and the front is raised just enough that
the door closes easily when opened about halfway.
To adjust the leveling legs,
turn the legs
counterclockwise to raise
the refrigerator,
clockwise to lower
it.
Turn counterclockwise to raise,
clockwise to lower.
To Next Page
Loading...
