17
SOLUTION
A) Replace the batteries
with 2 new AAA
alkaline batteries.
B) Check if batteries
are properly installed.
A) Try all the codes
listed for your brand.
your video devices.
B) Try the Code Search
method on Page 16.
Start Code Search over
again to locate
properlythe proper
code for full compati-
bility
Try the VCR code for
your brand. Some
combo units, however,
may require both a TV
and VCR code for full
operation.
As a safety feature on
your remote, you
must press the REC
button twice.
NOTE: For AUX retrieving,
press AUX button followed
by the device button.
3. Press and release CODE
SEARCH. The INDICATOR
LIGHTwill turn off.
4. Starting with 0 on the
keypad, press the number
buttons in order (0-9) until
the INDICATOR LIGHT blinks.
5. The number which causes the INDICATOR LIGHT
to blink is the first digit of your code.
6. Repeat Step 4 until you have retrieved all three
numbers in the code.
Trouble Shooting
PROBLEM
Red light not blinking when
you press any key.
The remote does not operate
your video devices.
Not performing commands
properly
Problems programming a
TV/VCR Combo Unit
VCR not responding
94925 Revised Size 2/25/02 4:00 PM Page 18
To Next Page
Loading...
Need help?
General
